-----Original Message----- From: Alexander Duyck [mailto:alexander.duyck@xxxxxxxxx] Sent: Saturday, June 1, 2019 2:57 AM To: Nagal, Amit UTC CCS <Amit.Nagal@xxxxxxx> Cc: linux-kernel@xxxxxxxxxxxxxxx; linux-mm@xxxxxxxxx; CHAWLA, RITU UTC CCS <RITU.CHAWLA@xxxxxxx> Subject: [External] Re: linux kernel page allocation failure and tuning of page cache On Fri, May 31, 2019 at 8:07 AM Nagal, Amit UTC CCS <Amit.Nagal@xxxxxxx> wrote: > > Hi > > We are using Renesas RZ/A1 processor based custom target board . linux kernel version is 4.9.123. > > 1) the platform is low memory platform having memory 64MB. > > 2) we are doing around 45MB TCP data transfer from PC to target using netcat utility .On Target , a process receives data over socket and writes the data to flash disk . > > 3) At the start of data transfer , we explicitly clear linux kernel cached memory by calling echo 3 > /proc/sys/vm/drop_caches . > > 4) during TCP data transfer , we could see free -m showing "free" getting dropped to almost 1MB and most of the memory appearing as "cached" > > # free -m > total used free shared buffers cached > Mem: 57 56 1 0 2 42 > -/+ buffers/cache: 12 45 > Swap: 0 0 0 > > 5) sometimes , we observed kernel memory getting exhausted as page allocation failure happens in kernel with the backtrace is printed below : > # [ 775.947949] nc.traditional: page allocation failure: order:0, mode:0x2080020(GFP_ATOMIC) > [ 775.956362] CPU: 0 PID: 1288 Comm: nc.traditional Tainted: G O 4.9.123-pic6-g31a13de-dirty #19 > [ 775.966085] Hardware name: Generic R7S72100 (Flattened Device Tree) > [ 775.972501] [<c0109829>] (unwind_backtrace) from [<c010796f>] > (show_stack+0xb/0xc) [ 775.980118] [<c010796f>] (show_stack) from > [<c0151de3>] (warn_alloc+0x89/0xba) [ 775.987361] [<c0151de3>] > (warn_alloc) from [<c0152043>] (__alloc_pages_nodemask+0x1eb/0x634) > [ 775.995790] [<c0152043>] (__alloc_pages_nodemask) from [<c0152523>] > (__alloc_page_frag+0x39/0xde) [ 776.004685] [<c0152523>] > (__alloc_page_frag) from [<c03190f1>] (__netdev_alloc_skb+0x51/0xb0) [ > 776.013217] [<c03190f1>] (__netdev_alloc_skb) from [<c02c1b6f>] > (sh_eth_poll+0xbf/0x3c0) [ 776.021342] [<c02c1b6f>] (sh_eth_poll) > from [<c031fd8f>] (net_rx_action+0x77/0x170) [ 776.029051] > [<c031fd8f>] (net_rx_action) from [<c011238f>] > (__do_softirq+0x107/0x160) [ 776.036896] [<c011238f>] (__do_softirq) > from [<c0112589>] (irq_exit+0x5d/0x80) [ 776.044165] [<c0112589>] > (irq_exit) from [<c012f4db>] (__handle_domain_irq+0x57/0x8c) [ 776.052007] [<c012f4db>] (__handle_domain_irq) from [<c01012e1>] (gic_handle_irq+0x31/0x48) [ 776.060362] [<c01012e1>] (gic_handle_irq) from [<c0108025>] (__irq_svc+0x65/0xac) [ 776.067835] Exception stack(0xc1cafd70 to 0xc1cafdb8) > [ 776.072876] fd60: 0002751c c1dec6a0 0000000c 521c3be5 > [ 776.081042] fd80: 56feb08e f64823a6 ffb35f7b feab513d f9cb0643 > 0000056c c1caff10 ffffe000 [ 776.089204] fda0: b1f49160 c1cafdc4 > c180c677 c0234ace 200e0033 ffffffff [ 776.095816] [<c0108025>] > (__irq_svc) from [<c0234ace>] (__copy_to_user_std+0x7e/0x430) [ > 776.103796] [<c0234ace>] (__copy_to_user_std) from [<c0241715>] > (copy_page_to_iter+0x105/0x250) [ 776.112503] [<c0241715>] > (copy_page_to_iter) from [<c0319aeb>] > (skb_copy_datagram_iter+0xa3/0x108) > [ 776.121469] [<c0319aeb>] (skb_copy_datagram_iter) from [<c03443a7>] > (tcp_recvmsg+0x3ab/0x5f4) [ 776.130045] [<c03443a7>] (tcp_recvmsg) > from [<c035e249>] (inet_recvmsg+0x21/0x2c) [ 776.137576] [<c035e249>] > (inet_recvmsg) from [<c031009f>] (sock_read_iter+0x51/0x6e) [ > 776.145384] [<c031009f>] (sock_read_iter) from [<c017795d>] > (__vfs_read+0x97/0xb0) [ 776.152967] [<c017795d>] (__vfs_read) from > [<c01781d9>] (vfs_read+0x51/0xb0) [ 776.159983] [<c01781d9>] > (vfs_read) from [<c0178aab>] (SyS_read+0x27/0x52) [ 776.166837] > [<c0178aab>] (SyS_read) from [<c0105261>] (ret_fast_syscall+0x1/0x54) >So it looks like you are interrupting the process that is draining the socket to service the interrupt that is filling it. I am curious what your tcp_rmem value is. If this is occurring often then you will likely build up a >backlog of packets in the receive buffer for the socket and that may be where all your memory is going. Thanks for the reply . # cat /proc/sys/net/ipv4/tcp_rmem 4096 87380 454688 the maximum value is less than 1MB here . which means that socket buffer is not consuming all the memory here right ? > [ 776.174308] Mem-Info: > [ 776.176650] active_anon:2037 inactive_anon:23 isolated_anon:0 [ > 776.176650] active_file:2636 inactive_file:7391 isolated_file:32 [ > 776.176650] unevictable:0 dirty:1366 writeback:1281 unstable:0 [ > 776.176650] slab_reclaimable:719 slab_unreclaimable:724 [ > 776.176650] mapped:1990 shmem:26 pagetables:159 bounce:0 [ > 776.176650] free:373 free_pcp:6 free_cma:0 [ 776.209062] Node 0 > active_anon:8148kB inactive_anon:92kB active_file:10544kB > inactive_file:29564kB unevictable:0kB isolated(anon):0kB > isolated(file):128kB mapped:7960kB dirty:5464kB writeback:5124kB > shmem:104kB writeback_tmp:0kB unstable:0kB pages_scanned:0 > all_unreclaimable? no [ 776.233602] Normal free:1492kB min:964kB > low:1204kB high:1444kB active_anon:8148kB inactive_anon:92kB > active_file:10544kB inactive_file:29564kB unevictable:0kB > writepending:10588kB present:65536kB managed:59304kB mlocked:0kB > slab_reclaimable:2876kB slab_unreclaimable:2896kB kernel_stack:1152kB > pagetables:636kB bounce:0kB free_pcp:24kB local_pcp:24kB free_cma:0kB > [ 776.265406] lowmem_reserve[]: 0 0 [ 776.268761] Normal: 7*4kB (H) > 5*8kB (H) 7*16kB (H) 5*32kB (H) 6*64kB (H) 2*128kB (H) 2*256kB (H) > 0*512kB 0*1024kB 0*2048kB 0*4096kB = 1492kB > 10071 total pagecache pages > [ 776.284124] 0 pages in swap cache > [ 776.287446] Swap cache stats: add 0, delete 0, find 0/0 [ > 776.292645] Free swap = 0kB [ 776.295532] Total swap = 0kB [ > 776.298421] 16384 pages RAM [ 776.301224] 0 pages HighMem/MovableOnly > [ 776.305052] 1558 pages reserved > > 6) we have certain questions as below : > a) how the kernel memory got exhausted ? at the time of low memory conditions in kernel , are the kernel page flusher threads , which should have written dirty pages from page cache to flash disk , not > >executing at right time ? is the kernel page reclaim mechanism not executing at right time ? >I suspect the pages are likely stuck in a state of buffering. In the case of sockets the packets will get queued up until either they can be serviced or the maximum size of the receive buffer as been exceeded >and they are dropped. My concern here is that why the reclaim procedure has not triggered ? > b) are there any parameters available within the linux memory subsystem with which the reclaim procedure can be monitored and fine tuned ? >I don't think freeing up more memory will solve the issue. I really think you probably should look at tuning the network settings. I suspect the socket itself is likely the thing holding all of the memory. > c) can some amount of free memory be reserved so that linux kernel does not caches it and kernel can use it for its other required page allocation ( particularly gfp_atomic ) as needed above on behalf of netcat nc process ? can some tuning be done in linux memory subsystem eg by using /proc/sys/vm/min_free_kbytes to achieve this objective . >Within the kernel we already have some emergency reserved that get dipped into if the PF_MEMALLOC flag is set. However that is usually reserved for the cases where you are booting off of something like >iscsi or NVMe over TCP. > d) can we be provided with further clues on how to debug this issue further for out of memory condition in kernel ? >My advice would be look at tuning your TCP socket values in sysctl. I suspect you are likely using a larger window then your system can currently handle given the memory constraints and that what you are >seeing is that all the memory is being consumed by buffering for the TCP socket. Any suggestions here what all TCP socket values I should look into and what values to tune to .
