(adding proper linux-c6x-dev list, sorry about the noise) On Wed, Jun 27, 2018 at 03:09:20PM +0300, Mike Rapoport wrote: > The c6x is already using memblock and does most of early memory > reservations with it, so it was only a matter of removing the bootmem > initialization and handover of the memory from memblock to bootmem. > > Signed-off-by: Mike Rapoport <rppt@xxxxxxxxxxxxxxxxxx> > --- > arch/c6x/Kconfig | 1 + > arch/c6x/kernel/setup.c | 26 +------------------------- > 2 files changed, 2 insertions(+), 25 deletions(-) > > diff --git a/arch/c6x/Kconfig b/arch/c6x/Kconfig > index bf59855628ac..054c7c963180 100644 > --- a/arch/c6x/Kconfig > +++ b/arch/c6x/Kconfig > @@ -14,6 +14,7 @@ config C6X > select GENERIC_IRQ_SHOW > select HAVE_ARCH_TRACEHOOK > select HAVE_MEMBLOCK > + select NO_BOOTMEM > select SPARSE_IRQ > select IRQ_DOMAIN > select OF > diff --git a/arch/c6x/kernel/setup.c b/arch/c6x/kernel/setup.c > index 786e36e2f61d..cc74cb9d349b 100644 > --- a/arch/c6x/kernel/setup.c > +++ b/arch/c6x/kernel/setup.c > @@ -296,7 +296,6 @@ notrace void __init machine_init(unsigned long dt_ptr) > > void __init setup_arch(char **cmdline_p) > { > - int bootmap_size; > struct memblock_region *reg; > > printk(KERN_INFO "Initializing kernel\n"); > @@ -353,16 +352,6 @@ void __init setup_arch(char **cmdline_p) > init_mm.end_data = memory_start; > init_mm.brk = memory_start; > > - /* > - * Give all the memory to the bootmap allocator, tell it to put the > - * boot mem_map at the start of memory > - */ > - bootmap_size = init_bootmem_node(NODE_DATA(0), > - memory_start >> PAGE_SHIFT, > - PAGE_OFFSET >> PAGE_SHIFT, > - memory_end >> PAGE_SHIFT); > - memblock_reserve(memory_start, bootmap_size); > - > unflatten_device_tree(); > > c6x_cache_init(); > @@ -397,22 +386,9 @@ void __init setup_arch(char **cmdline_p) > /* Initialize the coherent memory allocator */ > coherent_mem_init(dma_start, dma_size); > > - /* > - * Free all memory as a starting point. > - */ > - free_bootmem(PAGE_OFFSET, memory_end - PAGE_OFFSET); > - > - /* > - * Then reserve memory which is already being used. > - */ > - for_each_memblock(reserved, reg) { > - pr_debug("reserved - 0x%08x-0x%08x\n", > - (u32) reg->base, (u32) reg->size); > - reserve_bootmem(reg->base, reg->size, BOOTMEM_DEFAULT); > - } > - > max_low_pfn = PFN_DOWN(memory_end); > min_low_pfn = PFN_UP(memory_start); > + max_pfn = max_low_pfn; > max_mapnr = max_low_pfn - min_low_pfn; > > /* Get kmalloc into gear */ > -- > 2.7.4 > -- Sincerely yours, Mike.