Re: [PATCH 7/9] x86/mm: Shadow stack page fault error checking

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, Jun 7, 2018 at 7:40 AM Yu-cheng Yu <yu-cheng.yu@xxxxxxxxx> wrote:
>
> If a page fault is triggered by a shadow stack access (e.g.
> call/ret) or shadow stack management instructions (e.g.
> wrussq), then bit[6] of the page fault error code is set.
>
> In access_error(), we check if a shadow stack page fault
> is within a shadow stack memory area.
>
> Signed-off-by: Yu-cheng Yu <yu-cheng.yu@xxxxxxxxx>

> diff --git a/arch/x86/mm/fault.c b/arch/x86/mm/fault.c
> index 73bd8c95ac71..2b3b9170109c 100644
> --- a/arch/x86/mm/fault.c
> +++ b/arch/x86/mm/fault.c
> @@ -1166,6 +1166,17 @@ access_error(unsigned long error_code, struct vm_area_struct *vma)
>                                        (error_code & X86_PF_INSTR), foreign))
>                 return 1;
>
> +       /*
> +        * Verify X86_PF_SHSTK is within a shadow stack VMA.
> +        * It is always an error if there is a shadow stack
> +        * fault outside a shadow stack VMA.
> +        */
> +       if (error_code & X86_PF_SHSTK) {
> +               if (!(vma->vm_flags & VM_SHSTK))
> +                       return 1;
> +               return 0;
> +       }
> +

What, if anything, would go wrong without this change?  It seems like
it might be purely an optimization.  If so, can you mention that in
the comment?




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [IETF Annouce]     [Bugtraq]     [Linux OMAP]     [Linux MIPS]     [eCos]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux