This patch addresses shortcoming in current boot process on machines that supports 5-level paging. If bootloader enables 64-bit mode with 4-level paging, we need to switch over to 5-level paging. The switching requires disabling paging. It works fine if kernel itself is loaded below 4G. If bootloader put the kernel above 4G (not sure if anybody does this), we would loose control as soon as paging is disabled as code becomes unreachable. This patch implements trampoline in lower memory to handle this situation. We only need the memory for very short time, until main kernel image setup its own page tables. We go though trampoline even if we don't have to: if we're already in 5-level paging mode or if we don't need to switch to it. This way the trampoline code gets tested not only in special rare case, but on every boot. Signed-off-by: Kirill A. Shutemov <kirill.shutemov@xxxxxxxxxxxxxxx> --- arch/x86/boot/compressed/head_64.S | 72 +++++++++++++++++++++++--------------- 1 file changed, 43 insertions(+), 29 deletions(-) diff --git a/arch/x86/boot/compressed/head_64.S b/arch/x86/boot/compressed/head_64.S index 33a47d5c6445..525972ca27b7 100644 --- a/arch/x86/boot/compressed/head_64.S +++ b/arch/x86/boot/compressed/head_64.S @@ -33,6 +33,7 @@ #include <asm/processor-flags.h> #include <asm/asm-offsets.h> #include <asm/bootparam.h> +#include "pgtable.h" /* * Locally defined symbols should be marked hidden: @@ -339,31 +340,22 @@ ENTRY(startup_64) call paging_prepare popq %rsi movq %rax, %rcx - andq $(~1UL), %rcx - - testq $1, %rax - jz lvl5 - - /* Clear additional page table */ - leaq lvl5_pgtable(%rbx), %rdi - xorq %rax, %rax - movq $(PAGE_SIZE/8), %rcx - rep stosq /* - * Setup current CR3 as the first and only entry in a new top level - * page table. + * Load address of trampoline_return into RDI. + * It will be used by trampoline to return to main code. */ - movq %cr3, %rdi - leaq 0x7 (%rdi), %rax - movq %rax, lvl5_pgtable(%rbx) + leaq trampoline_return(%rip), %rdi /* Switch to compatibility mode (CS.L = 0 CS.D = 1) via far return */ pushq $__KERNEL32_CS - leaq compatible_mode(%rip), %rax + andq $(~1UL), %rax /* Clear bit 0: encode if 5-level paging neeeded */ + leaq TRAMPOLINE_32BIT_CODE_OFF(%rax), %rax pushq %rax lretq -lvl5: +trampoline_return: + /* Restore stack, 32-bit trampoline uses own stack */ + leaq boot_stack_end(%rbx), %rsp /* Zero EFLAGS */ pushq $0 @@ -501,36 +493,51 @@ relocated: jmp *%rax .code32 +/* + * This is 32-bit trampoline that will be copied over to low memory. + * + * RDI contains return address (might be above 4G). + * ECX contains the base address of trampoline memory. + * Bit 0 of ECX encodes if 5-level paging is required. + */ ENTRY(trampoline_32bit_src) -compatible_mode: /* Setup data and stack segments */ movl $__KERNEL_DS, %eax movl %eax, %ds movl %eax, %ss + movl %ecx, %edx + andl $(~1UL), %edx + + /* Setup new stack at the end of trampoline memory */ + leal TRAMPOLINE_32BIT_STACK_END (%edx), %esp + /* Disable paging */ movl %cr0, %eax btrl $X86_CR0_PG_BIT, %eax movl %eax, %cr0 - /* Point CR3 to 5-level paging */ - leal lvl5_pgtable(%ebx), %eax + /* Point CR3 to trampoline top level page table */ + leal TRAMPOLINE_32BIT_PGTABLE_OFF (%edx), %eax movl %eax, %cr3 /* Enable PAE and LA57 mode */ movl %cr4, %eax - orl $(X86_CR4_PAE | X86_CR4_LA57), %eax + orl $X86_CR4_PAE, %eax + + /* Bit 0 of ECX encodes if 5-level paging is required */ + testl $1, %ecx + jz 1f + orl $X86_CR4_LA57, %eax +1: movl %eax, %cr4 - /* Calculate address we are running at */ - call 1f -1: popl %edi - subl $1b, %edi + /* Calculate address of paging_enabled once we are in trampoline */ + leal paging_enabled - trampoline_32bit_src + TRAMPOLINE_32BIT_CODE_OFF (%edx), %eax /* Prepare stack for far return to Long Mode */ pushl $__KERNEL_CS - leal lvl5(%edi), %eax - push %eax + pushl %eax /* Enable paging back */ movl $(X86_CR0_PG | X86_CR0_PE), %eax @@ -538,6 +545,15 @@ compatible_mode: lret + .code64 +paging_enabled: + /* Return from trampoline */ + jmp *%rdi + + /* Bound size of trampoline code */ + .org trampoline_32bit_src + TRAMPOLINE_32BIT_CODE_SIZE + + .code32 no_longmode: /* This isn't an x86-64 CPU so hang */ 1: @@ -595,5 +611,3 @@ boot_stack_end: .balign 4096 pgtable: .fill BOOT_PGT_SIZE, 1, 0 -lvl5_pgtable: - .fill PAGE_SIZE, 1, 0 -- 2.15.0 -- To unsubscribe, send a message with 'unsubscribe linux-mm' in the body to majordomo@xxxxxxxxx. For more info on Linux MM, see: http://www.linux-mm.org/ . Don't email: <a href=mailto:"dont@xxxxxxxxx";> email@xxxxxxxxx </a>
