Hi all,
As part of the efforts to support increasing next-generation NIC speeds,
I am investigating SW bottlenecks in network stack receive flow.
Here I share some numbers I got for a simple experiment, in which I
simulate the page allocation rate needed in 200Gpbs NICs.
I ran the test below over 3 different (modified) mlx5 driver versions,
loaded on server side (RX):
1) RX page cache disabled, 2 packets per page.
2) RX page cache disabled, one packet per page.
3) Huge RX page cache, one packet per page.
All page allocations are of order 0.
NIC: Connectx-5 100 Gbps.
CPU: Intel(R) Xeon(R) CPU E5-2680 v3 @ 2.50GHz
Test:
128 TCP streams (using super_netperf).
Changing num of RX queues.
HW LRO OFF, GRO ON, MTU 1500.
Observe: BW as a function of num RX queues.
Results:
Driver #1:
#rings BW (Mbps)
1 23,813
2 44,086
3 62,128
4 78,058
6 94,210 (linerate)
8 94,205 (linerate)
12 94,202 (linerate)
16 94,191 (linerate)
Driver #2:
#rings BW (Mbps)
1 18,835
2 36,716
3 50,521
4 61,746
6 63,637
8 60,299
12 51,048
16 43,337
Driver #3:
#rings BW (Mbps)
1 19,316
2 44,850
3 69,549
4 87,434
6 94,342 (linerate)
8 94,350 (linerate)
12 94,327 (linerate)
16 94,327 (linerate)
Insights:
Major degradation between #1 and #2, not getting any close to linerate!
Degradation is fixed between #2 and #3.
This is because page allocator cannot stand the higher allocation rate.
In #2, we also see that the addition of rings (cores) reduces BW (!!),
as result of increasing congestion over shared resources.
Congestion in this case is very clear.
When monitored in perf top:
85.58% [kernel] [k] queued_spin_lock_slowpath
I think that page allocator issues should be discussed separately:
1) Rate: Increase the allocation rate on a single core.
2) Scalability: Reduce congestion and sync overhead between cores.
This is clearly the current bottleneck in the network stack receive flow.
I know about some efforts that were made in the past two years.
For example the ones from Jesper et al.:
- Page-pool (not accepted AFAIK).
- Page-allocation bulking.
- Optimize order-0 allocations in Per-Cpu-Pages.
I am not an mm expert, but wanted to raise the issue again, to combine
the efforts and hear from you guys about status and possible directions.
Best regards,
Tariq Toukan
--
To unsubscribe, send a message with 'unsubscribe linux-mm' in
the body to majordomo@xxxxxxxxx. For more info on Linux MM,
see: http://www.linux-mm.org/ .
Don't email: <a href=mailto:"dont@xxxxxxxxx";> email@xxxxxxxxx </a>
