On Wed, Jun 07, 2017 at 02:17:21PM -0500, Tom Lendacky wrote:
> Since DMA addresses will effectively look like 48-bit addresses when the
> memory encryption mask is set, SWIOTLB is needed if the DMA mask of the
> device performing the DMA does not support 48-bits. SWIOTLB will be
> initialized to create decrypted bounce buffers for use by these devices.
>
> Signed-off-by: Tom Lendacky <thomas.lendacky@xxxxxxx>
> ---
...
> diff --git a/init/main.c b/init/main.c
> index df58a41..7125b5f 100644
> --- a/init/main.c
> +++ b/init/main.c
> @@ -488,6 +488,10 @@ void __init __weak thread_stack_cache_init(void)
> }
> #endif
>
> +void __init __weak mem_encrypt_init(void)
> +{
> +}
void __init __weak mem_encrypt_init(void) { }
saves some real estate. Please do that for the rest of the stubs you're
adding, for the next version.
> +
> /*
> * Set up kernel memory allocators
> */
> @@ -640,6 +644,15 @@ asmlinkage __visible void __init start_kernel(void)
> */
> locking_selftest();
>
> + /*
> + * This needs to be called before any devices perform DMA
> + * operations that might use the SWIOTLB bounce buffers.
> + * This call will mark the bounce buffers as decrypted so
> + * that their usage will not cause "plain-text" data to be
> + * decrypted when accessed.
s/This call/It/
> + */
> + mem_encrypt_init();
> +
> #ifdef CONFIG_BLK_DEV_INITRD
> if (initrd_start && !initrd_below_start_ok &&
> page_to_pfn(virt_to_page((void *)initrd_start)) < min_low_pfn) {
> diff --git a/lib/swiotlb.c b/lib/swiotlb.c
> index a8d74a7..74d6557 100644
> --- a/lib/swiotlb.c
> +++ b/lib/swiotlb.c
> @@ -30,6 +30,7 @@
> #include <linux/highmem.h>
> #include <linux/gfp.h>
> #include <linux/scatterlist.h>
> +#include <linux/mem_encrypt.h>
>
> #include <asm/io.h>
> #include <asm/dma.h>
> @@ -155,6 +156,17 @@ unsigned long swiotlb_size_or_default(void)
> return size ? size : (IO_TLB_DEFAULT_SIZE);
> }
>
> +void __weak swiotlb_set_mem_attributes(void *vaddr, unsigned long size)
> +{
> +}
As above.
--
Regards/Gruss,
Boris.
Good mailing practices for 400: avoid top-posting and trim the reply.
--
To unsubscribe, send a message with 'unsubscribe linux-mm' in
the body to majordomo@xxxxxxxxx. For more info on Linux MM,
see: http://www.linux-mm.org/ .
Don't email: <a href=mailto:"dont@xxxxxxxxx";> email@xxxxxxxxx </a>
