Hi Michal, On 05/13/2016 04:01 PM, Michal Hocko wrote: > On Fri 13-05-16 14:15:35, Mason wrote: >> On 13/05/2016 13:44, Michal Hocko wrote: >> >>> Anyway, this is my laptop where I do not run anything really special >>> (xfce, browser, few consoles, git, mutt): >>> $ grep Commit /proc/meminfo >>> CommitLimit: 3497288 kB >>> Committed_AS: 3560804 kB >>> >>> I am running with the default overcommit setup so I do not care about >>> the limit but the Committed_AS will tell you how much is actually >>> committed. I am definitelly not out of memory: >>> $ free >>> total used free shared buff/cache available >>> Mem: 3922584 1724120 217336 105264 1981128 2036164 >>> Swap: 1535996 386364 1149632 >> >> I see. Thanks for the data point. >> >> I had a different type of system in mind. >> 256 to 512 MB of RAM, no swap. >> Perhaps Sebastian's choice could be made to depend on CONFIG_EMBEDDED, >> rather than CONFIG_EXPERT? > > Even if the overcommit behavior is different on those systems the > primary question hasn't been answered yet. Why cannot this be done from > the userspace? In other words what wouldn't work properly? > You are right, and I said that since the beginning, nothing prevents the userspace from doing it. But it'd be interesting to know the history of this option, for example, why it is left for userspace. Are there systems that dynamically change this setting? Best regards, Sebastian -- To unsubscribe, send a message with 'unsubscribe linux-mm' in the body to majordomo@xxxxxxxxx. For more info on Linux MM, see: http://www.linux-mm.org/ . Don't email: <a href=mailto:"dont@xxxxxxxxx";> email@xxxxxxxxx </a>