[RFC PATCH] mm: CONFIG_NR_ZONES_EXTENDED

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



ZONE_DEVICE (merged in 4.3) and ZONE_CMA (proposed) are examples of new
mm zones that are bumping up against the current maximum limit of 4
zones, i.e. 2 bits in page->flags.  When adding a zone this equation
still needs to be satisified:

    SECTIONS_WIDTH + ZONES_WIDTH + NODES_SHIFT + LAST_CPUPID_SHIFT
	  <= BITS_PER_LONG - NR_PAGEFLAGS

ZONE_DEVICE currently tries to satisfy this equation by requiring that
ZONE_DMA be disabled, but this is untenable given generic kernels want
to support ZONE_DEVICE and ZONE_DMA simultaneously.  ZONE_CMA would like
to increase the amount of memory covered per section, but that limits
the minimum granularity at which consecutive memory ranges can be added
via devm_memremap_pages().

The trade-off of what is acceptable to sacrifice depends heavily on the
platform.  For example, ZONE_CMA is targeted for 32-bit platforms where
page->flags is constrained, but those platforms likely do not care about
the minimum granularity of memory hotplug.  A big iron machine with 1024
numa nodes can likely sacrifice ZONE_DMA where a general purpose
distribution kernel can not.

CONFIG_NR_ZONES_EXTENDED is a configuration symbol that gets selected
when the number of configured zones exceeds 4.  It documents the
configuration symbols and definitions that get modified when ZONES_WIDTH
is greater than 2.

For now, it steals a bit from NODES_SHIFT.  Later on it can be used to
document the definitions that get modified when a 32-bit configuration
wants more zone bits.

Note that GFP_ZONE_TABLE poses an interesting constraint since
include/linux/gfp.h gets included by the 32-bit portion of a 64-bit
build.  We need to be careful to only build the table for zones that
have a corresponding gfp_t flag.  GFP_ZONES_SHIFT is introduced for this
purpose.  This patch does not attempt to solve the problem of adding a
new zone that also has a corresponding GFP_ flag.

Cc: Mel Gorman <mgorman@xxxxxxx>
Cc: Rik van Riel <riel@xxxxxxxxxx>
Cc: Joonsoo Kim <iamjoonsoo.kim@xxxxxxx>
Cc: Dave Hansen <dave.hansen@xxxxxxxxxxxxxxx>
Link: https://bugzilla.kernel.org/show_bug.cgi?id=110931
Fixes: 033fbae988fc ("mm: ZONE_DEVICE for "device memory"")
Cc: Sudip Mukherjee <sudipm.mukherjee@xxxxxxxxx>
Reported-by: Mark <markk@xxxxxxxxxxx>
Signed-off-by: Dan Williams <dan.j.williams@xxxxxxxxx>
---
 arch/x86/Kconfig                  |    6 ++++--
 include/linux/gfp.h               |   33 ++++++++++++++++++++-------------
 include/linux/page-flags-layout.h |    2 ++
 mm/Kconfig                        |    7 +++++--
 4 files changed, 31 insertions(+), 17 deletions(-)

diff --git a/arch/x86/Kconfig b/arch/x86/Kconfig
index 330e738ccfc1..9dfc52eb3976 100644
--- a/arch/x86/Kconfig
+++ b/arch/x86/Kconfig
@@ -1409,8 +1409,10 @@ config NUMA_EMU
 
 config NODES_SHIFT
 	int "Maximum NUMA Nodes (as a power of 2)" if !MAXSMP
-	range 1 10
-	default "10" if MAXSMP
+	range 1 10 if !NR_ZONES_EXTENDED
+	range 1 9 if NR_ZONES_EXTENDED
+	default "10" if MAXSMP && !NR_ZONES_EXTENDED
+	default "9" if MAXSMP && NR_ZONES_EXTENDED
 	default "6" if X86_64
 	default "3"
 	depends on NEED_MULTIPLE_NODES
diff --git a/include/linux/gfp.h b/include/linux/gfp.h
index 28ad5f6494b0..5979c2c80140 100644
--- a/include/linux/gfp.h
+++ b/include/linux/gfp.h
@@ -329,22 +329,29 @@ static inline bool gfpflags_allow_blocking(const gfp_t gfp_flags)
  *       0xe    => BAD (MOVABLE+DMA32+HIGHMEM)
  *       0xf    => BAD (MOVABLE+DMA32+HIGHMEM+DMA)
  *
- * ZONES_SHIFT must be <= 2 on 32 bit platforms.
+ * GFP_ZONES_SHIFT must be <= 2 on 32 bit platforms.
  */
 
-#if 16 * ZONES_SHIFT > BITS_PER_LONG
-#error ZONES_SHIFT too large to create GFP_ZONE_TABLE integer
+#if defined(CONFIG_ZONE_DEVICE) && (MAX_NR_ZONES-1) <= 4
+/* ZONE_DEVICE is not a valid GFP zone specifier */
+#define GFP_ZONES_SHIFT 2
+#else
+#define GFP_ZONES_SHIFT ZONES_SHIFT
+#endif
+
+#if 16 * GFP_ZONES_SHIFT > BITS_PER_LONG
+#error GFP_ZONES_SHIFT too large to create GFP_ZONE_TABLE integer
 #endif
 
 #define GFP_ZONE_TABLE ( \
-	(ZONE_NORMAL << 0 * ZONES_SHIFT)				      \
-	| (OPT_ZONE_DMA << ___GFP_DMA * ZONES_SHIFT)			      \
-	| (OPT_ZONE_HIGHMEM << ___GFP_HIGHMEM * ZONES_SHIFT)		      \
-	| (OPT_ZONE_DMA32 << ___GFP_DMA32 * ZONES_SHIFT)		      \
-	| (ZONE_NORMAL << ___GFP_MOVABLE * ZONES_SHIFT)			      \
-	| (OPT_ZONE_DMA << (___GFP_MOVABLE | ___GFP_DMA) * ZONES_SHIFT)	      \
-	| (ZONE_MOVABLE << (___GFP_MOVABLE | ___GFP_HIGHMEM) * ZONES_SHIFT)   \
-	| (OPT_ZONE_DMA32 << (___GFP_MOVABLE | ___GFP_DMA32) * ZONES_SHIFT)   \
+	(ZONE_NORMAL << 0 * GFP_ZONES_SHIFT)					\
+	| (OPT_ZONE_DMA << ___GFP_DMA * GFP_ZONES_SHIFT)			\
+	| (OPT_ZONE_HIGHMEM << ___GFP_HIGHMEM * GFP_ZONES_SHIFT)		\
+	| (OPT_ZONE_DMA32 << ___GFP_DMA32 * GFP_ZONES_SHIFT)		      	\
+	| (ZONE_NORMAL << ___GFP_MOVABLE * GFP_ZONES_SHIFT)			\
+	| (OPT_ZONE_DMA << (___GFP_MOVABLE | ___GFP_DMA) * GFP_ZONES_SHIFT)	\
+	| (ZONE_MOVABLE << (___GFP_MOVABLE | ___GFP_HIGHMEM) * GFP_ZONES_SHIFT)	\
+	| (OPT_ZONE_DMA32 << (___GFP_MOVABLE | ___GFP_DMA32) * GFP_ZONES_SHIFT)	\
 )
 
 /*
@@ -369,8 +376,8 @@ static inline enum zone_type gfp_zone(gfp_t flags)
 	enum zone_type z;
 	int bit = (__force int) (flags & GFP_ZONEMASK);
 
-	z = (GFP_ZONE_TABLE >> (bit * ZONES_SHIFT)) &
-					 ((1 << ZONES_SHIFT) - 1);
+	z = (GFP_ZONE_TABLE >> (bit * GFP_ZONES_SHIFT)) &
+					 ((1 << GFP_ZONES_SHIFT) - 1);
 	VM_BUG_ON((GFP_ZONE_BAD >> bit) & 1);
 	return z;
 }
diff --git a/include/linux/page-flags-layout.h b/include/linux/page-flags-layout.h
index da523661500a..77b078c103b2 100644
--- a/include/linux/page-flags-layout.h
+++ b/include/linux/page-flags-layout.h
@@ -17,6 +17,8 @@
 #define ZONES_SHIFT 1
 #elif MAX_NR_ZONES <= 4
 #define ZONES_SHIFT 2
+#elif MAX_NR_ZONES <= 8
+#define ZONES_SHIFT 3
 #else
 #error ZONES_SHIFT -- too many zones configured adjust calculation
 #endif
diff --git a/mm/Kconfig b/mm/Kconfig
index 97a4e06b15c0..cb5377624df3 100644
--- a/mm/Kconfig
+++ b/mm/Kconfig
@@ -651,8 +651,6 @@ config IDLE_PAGE_TRACKING
 
 config ZONE_DEVICE
 	bool "Device memory (pmem, etc...) hotplug support" if EXPERT
-	default !ZONE_DMA
-	depends on !ZONE_DMA
 	depends on MEMORY_HOTPLUG
 	depends on MEMORY_HOTREMOVE
 	depends on X86_64 #arch_add_memory() comprehends device memory
@@ -666,5 +664,10 @@ config ZONE_DEVICE
 
 	  If FS_DAX is enabled, then say Y.
 
+config NR_ZONES_EXTENDED
+	bool
+	default n if !64BIT
+	default y if ZONE_DEVICE && ZONE_DMA && ZONE_DMA32
+
 config FRAME_VECTOR
 	bool

--
To unsubscribe, send a message with 'unsubscribe linux-mm' in
the body to majordomo@xxxxxxxxx.  For more info on Linux MM,
see: http://www.linux-mm.org/ .
Don't email: <a href=mailto:"dont@xxxxxxxxx";> email@xxxxxxxxx </a>



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [IETF Annouce]     [Bugtraq]     [Linux]     [Linux OMAP]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]