On Fri 18-06-10 12:21:36, Peter Zijlstra wrote:
> On Thu, 2010-06-17 at 20:04 +0200, Jan Kara wrote:
> > +/* Wait until write_chunk is written or we get below dirty limits */
> > +void bdi_wait_written(struct backing_dev_info *bdi, long write_chunk)
> > +{
> > + struct bdi_written_count wc = {
> > + .list = LIST_HEAD_INIT(wc.list),
> > + .written = write_chunk,
> > + };
> > + DECLARE_WAITQUEUE(wait, current);
> > + int pause = 1;
> > +
> > + bdi_add_writer(bdi, &wc, &wait);
> > + for (;;) {
> > + if (signal_pending_state(TASK_KILLABLE, current))
> > + break;
> > +
> > + /*
> > + * Make the task just killable so that tasks cannot circumvent
> > + * throttling by sending themselves non-fatal signals...
> > + */
> > + __set_current_state(TASK_KILLABLE);
> > + io_schedule_timeout(pause);
> > +
> > + /*
> > + * The following check is save without wb_written_wait.lock
> > + * because once bdi_remove_writer removes us from the list
> > + * noone will touch us and it's impossible for list_empty check
> > + * to trigger as false positive. The barrier is there to avoid
> > + * missing the wakeup when we are removed from the list.
> > + */
> > + smp_rmb();
> > + if (list_empty(&wc.list))
> > + break;
> > +
> > + if (!dirty_limits_exceeded(bdi))
> > + break;
> > +
> > + /*
> > + * Increase the delay for each loop, up to our previous
> > + * default of taking a 100ms nap.
> > + */
> > + pause <<= 1;
> > + if (pause > HZ / 10)
> > + pause = HZ / 10;
> > + }
> > +
> > + spin_lock_irq(&bdi->wb_written_wait.lock);
> > + __remove_wait_queue(&bdi->wb_written_wait, &wait);
> > + if (!list_empty(&wc.list))
> > + bdi_remove_writer(bdi, &wc);
> > + spin_unlock_irq(&bdi->wb_written_wait.lock);
> > +}
>
> OK, so the whole pause thing is simply because we don't get a wakeup
> when we drop below the limit, right?
Yes. I will write a comment about it before the loop. I was also thinking
about sending a wakeup when we get below limits but then all threads would
start thundering the device at the same time and likely cause a congestion
again. This way we might get a smoother start. But I'll have to measure
whether we aren't too unfair with this approach...
Honza
--
Jan Kara <jack@xxxxxxx>
SUSE Labs, CR
--
To unsubscribe, send a message with 'unsubscribe linux-mm' in
the body to majordomo@xxxxxxxxxx For more info on Linux MM,
see: http://www.linux-mm.org/ .
Don't email: <a href=mailto:"dont@xxxxxxxxx";> email@xxxxxxxxx </a>