No major change since V6, just looks nicer.
Changelog since V6
o Make the nested anon_vma lock taking prettier
Changelog since V5
o Have rmap_walk take anon_vma locks in order starting from the "root"
o Ensure that mm_take_all_locks locks VMAs in the same order
Changelog since V4
o Switch back anon_vma locking to put bulk of locking in rmap_walk
o Fix anon_vma lock ordering in exec vs migration race
Changelog since V3
o Rediff against the latest upstream tree
o Improve the patch changelog a little (thanks Peterz)
Changelog since V2
o Drop fork changes
o Avoid pages in temporary stacks during exec instead of migration pte
lazy cleanup
o Drop locking-related patch and replace with Rik's
Changelog since V1
o Handle the execve race
o Be sure that rmap_walk() releases the correct VMA lock
o Hold the anon_vma lock for the address lookup and the page remap
o Add reviewed-bys
Broadly speaking, migration works by locking a page, unmapping it, putting
a migration PTE in place that looks like a swap entry, copying the page and
remapping the page removing the old migration PTE before unlocking the page.
If a fault occurs, the faulting process waits until migration completes.
The problem is that there are some races that either allow migration PTEs
to be left left behind. Migration still completes and the page is unlocked
but later a fault will call migration_entry_to_page() and BUG() because the
page is not locked. It's not possible to just clean up the migration PTE
because the page it points to has been potentially freed and reused. This
series aims to close the races.
Patch 1 of this series is about the of locking of anon_vma in migration versus
vma_adjust. While I am not aware of any reproduction cases, it is potentially
racy. This patch is an alternative to Rik's "heavy lock" approach posted
at http://lkml.org/lkml/2010/5/3/155. With the patch, rmap_walk finds the
"root" anon_vma and starts locking from there, locking each new anon_vma
as it finds it. As long as the order is preserved, there is no deadlock.
In vma_adjust, the anon_vma locks are acquired under similar conditions
to 2.6.33 so that walkers will block until VMA changes are complete. The
rmap_walk changes potentially slows down migration and aspects of page
reclaim a little but they are the less important path.
Patch 2 of this series addresses the swapops bug reported that is a race
between migration and execve where pages get migrated from the temporary
stack before it is moved. To avoid migration PTEs being left behind,
a temporary VMA is put in place so that a migration PTE in either the
temporary stack or the relocated stack can be found.
The reproduction case for the races was as follows;
1. Run kernel compilation in a loop
2. Start four processes, each of which creates one mapping. The three stress
different aspects of the problem. The operations they undertake are;
a) Forks a hundred children, each of which faults the mapping
Purpose: stress tests migration pte removal
b) Forks a hundred children, each which punches a hole in the mapping
and faults what remains
Purpose: stress test VMA manipulations during migration
c) Forks a hundred children, each of which execs and calls echo
Purpose: stress test the execve race
d) Size the mapping to be 1.5 times physical memory. Constantly
memset it
Purpose: stress swapping
3. Constantly compact memory using /proc/sys/vm/compact_memory so migration
is active all the time. In theory, you could also force this using
sys_move_pages or memory hot-remove but it'd be nowhere near as easy
to test.
Compaction is the easiest way to trigger these bugs which is not going to
be in 2.6.34 but in theory the problem also affects memory hot-remove.
There were some concerns with patch 2 that performance would be impacted. To
check if this was the case I ran kernbench, aim9 and sysbench. AIM9 in
particular was of interest as it has an exec microbenchmark.
kernbench-vanilla fixraces-v5r1
Elapsed mean 103.40 ( 0.00%) 103.35 ( 0.05%)
Elapsed stddev 0.09 ( 0.00%) 0.13 (-55.72%)
User mean 313.50 ( 0.00%) 313.15 ( 0.11%)
User stddev 0.61 ( 0.00%) 0.20 (66.70%)
System mean 55.50 ( 0.00%) 55.85 (-0.64%)
System stddev 0.48 ( 0.00%) 0.15 (68.98%)
CPU mean 356.25 ( 0.00%) 356.50 (-0.07%)
CPU stddev 0.43 ( 0.00%) 0.50 (-15.47%)
Nothing special there and kernbench is fork+exec heavy. The patched kernel
is slightly faster on wall time but it's well within the noise. System time
is slightly slower but again, it's within the noise.
AIM9
aim9-vanilla fixraces-v5r1
creat-clo 116813.86 ( 0.00%) 117980.34 ( 0.99%)
page_test 270923.33 ( 0.00%) 268668.56 (-0.84%)
brk_test 2551558.07 ( 0.00%) 2649450.00 ( 3.69%)
signal_test 279866.67 ( 0.00%) 279533.33 (-0.12%)
exec_test 226.67 ( 0.00%) 232.67 ( 2.58%)
fork_test 4261.91 ( 0.00%) 4110.98 (-3.67%)
link_test 53534.78 ( 0.00%) 54076.49 ( 1.00%)
So, here exec and fork aren't showing up major worries. exec is faster but
these tests can be so sensitive to starting conditions that I tend not to
read much into them unless there are major differences.
SYSBENCH
sysbench-vanilla fixraces-v5r1
1 14177.73 ( 0.00%) 14218.41 ( 0.29%)
2 27647.23 ( 0.00%) 27774.14 ( 0.46%)
3 31395.69 ( 0.00%) 31499.95 ( 0.33%)
4 49866.54 ( 0.00%) 49713.49 (-0.31%)
5 49919.58 ( 0.00%) 49524.21 (-0.80%)
6 49532.97 ( 0.00%) 49397.60 (-0.27%)
7 49465.79 ( 0.00%) 49384.14 (-0.17%)
8 49483.33 ( 0.00%) 49186.49 (-0.60%)
These figures also show no differences worth talking about.
While the extra allocation in patch 2 would appear to slow down exec somewhat,
it's not by any amount that matters. As it is in exec, it means that anon_vmas
have likely been freed very recently so the allocation will be cache-hot and
cpu-local. It is possible to special-case migration to avoid migrating pages
in the temporary stack, but fixing it in exec is a more maintainable approach.
fs/exec.c | 37 ++++++++++++++++++++--
include/linux/rmap.h | 2 +
mm/ksm.c | 20 ++++++++++--
mm/mmap.c | 14 +++++++-
mm/rmap.c | 81 +++++++++++++++++++++++++++++++++++++++++++++-----
5 files changed, 137 insertions(+), 17 deletions(-)
Andrea Arcangeli (1):
mm,migration: Fix race between shift_arg_pages and rmap_walk by
guaranteeing rmap_walk finds PTEs created within the temporary
stack
Mel Gorman (1):
mm,migration: Prevent rmap_walk_[anon|ksm] seeing the wrong VMA
information
fs/exec.c | 37 +++++++++++++++++--
include/linux/rmap.h | 4 ++
mm/ksm.c | 13 ++++++-
mm/mmap.c | 14 ++++++-
mm/rmap.c | 97 ++++++++++++++++++++++++++++++++++++++++++++++----
5 files changed, 151 insertions(+), 14 deletions(-)
--
To unsubscribe, send a message with 'unsubscribe linux-mm' in
the body to majordomo@xxxxxxxxxx For more info on Linux MM,
see: http://www.linux-mm.org/ .
Don't email: <a href=mailto:"dont@xxxxxxxxx";> email@xxxxxxxxx </a>