On Wed, Apr 14, 2010 at 01:36:56AM +0200, Janos Haar wrote: > ----- Original Message ----- From: "Dave Chinner" > >On Tue, Apr 13, 2010 at 11:23:36AM +0200, Janos Haar wrote: > >>>If you run: > >>> > >>>$ xfs_db -r -c "inode 474253940" -c p /dev/sdb2 > >>> > >>>Then I can can confirm whether there is corruption on disk or not. > >>>Probably best to sample multiple of the inode numbers from the above > >>>list of bad inodes. > >> > >>Here is the log: > >>http://download.netcenter.hu/bughunt/20100413/debug.log > > > >There are multiple fields in the inode that are corrupted. > >I am really surprised that xfs-repair - even an old version - is not > >picking up the corruption.... > > I think i know now the reason.... > My case starting to turn into more and more interesting. > > (Just a little note for remember: tuesday night, i have run the old > 2.8.11 xfs_repair on the partiton wich was reported as corrupt by > the kernel, but it was clean. > The system was not restarted!) > > Like you suggested, today, i have tried to make a backup from the data. > During the copy, the kernel reported a lot of corrupted entries > again, and finally the kernel crashed! (with the 19 patch pack) > Unfortunately the kernel can't write the debug info into the syslog. > The system restarted automatically, the service runs again, and i > can't do another backup attempt because force of the owner. > Today night, when the traffic was in the low period, i have stopped > the service, umount the partition, and repeat the xfs_repair on the > previously reported partition on more ways. > > Here you can see the results: > xfs_repair 2.8.11 run #1: > http://download.netcenter.hu/bughunt/20100413/repair2811-nr1.log So this successfully detected and repaired the corruption. I don't think this is new corruption - the corrupted inode numbers are the same as you reported a few days back. > xfs_repair 2.8.11 run #2: > http://download.netcenter.hu/bughunt/20100413/repair2811-nr2.log > > echo 3 >/proc/sys/vm/drop_caches - performed > > xfs_repair 2.8.11 run #3: > http://download.netcenter.hu/bughunt/20100413/repair2811-nr3.log These two are clearing lost+found and rediscovering the diesconnected inodes that were discovered in the first pass. Nothing wrng here, that's just the way older repair versions behaved. > xfs_reapir 3.1.1 run #1: > http://download.netcenter.hu/bughunt/20100413/repair311-nr1.log And this detected nothing wrong, either. > For me, it looks like the FS gets corrupted between tuesday night > and today night. > Note: because i am expecting kernel crashes, the dirty data flush > was set for some miliseconds timeout only for prevent too much data > lost. > It was one kernel crash in this period, but the XFS have journal, > and should be cleaned correctly. (i don't think this is the problem) > > The other interesting thing is, why only this partition gets > corrupted? (again, and again?) Can you reporduce the corruption again now that the filesystem has been repaired? I want to know (if the corruption appears again) whether it appears in the same location as this one. > >>I mean, if i am right, the hw memory problem makes only 1-2 bit > >>corruption seriously, and the sw page handling problem makes bad > >>memory pages, no? > > > >RAM ECC guarantees correction of single bit errors and detection of > >double bit errors (which cause the kernel to panic, IIRC). I can't > >tell you what happens when larger errors occur, though... > > Yes, but this system have non-ECC ram unfortunately. If your hardware doesn't have ECC, then you can't rule out anything - even a dodgy power supply can cause this sort of transient problem. I'm not saying that this is the cause, but I've been assuming that you're actually running hardware with ECC on RAM, caches, buses, etc. > This makes me think this is sw problem, and not a simple memory > corruption, or the corruption can appear only for a short of time in > the hw. If you can take the performance hit, turn on the kernel memory leak detector and see if that catches anything. Cheers, Dave. -- Dave Chinner david@xxxxxxxxxxxxx -- To unsubscribe, send a message with 'unsubscribe linux-mm' in the body to majordomo@xxxxxxxxxx For more info on Linux MM, see: http://www.linux-mm.org/ . Don't email: <a href=mailto:"dont@xxxxxxxxx";> email@xxxxxxxxx </a>