As requested I've combined my two series into a single one to provide some better context for reviewers. I'm not sure which trees the patches should go in via. The first two are reasonably independent and could go in via linux-pm. I guess technically the last one could go via linux-i2c but it needs the and the bindings/dts updates which would probably make sense to come via linux-mips. -- 2.46.1 Chris Packham (6): dt-bindings: reset: syscon-reboot: Add reg property power: reset: syscon-reboot: Accept reg property dt-bindings: mfd: Add Realtek RTL9300 switch peripherals mips: dts: realtek: Add syscon-reboot node mips: dts: realtek: Add I2C controllers i2c: Add driver for the RTL9300 I2C controller .../bindings/i2c/realtek,rtl9300-i2c.yaml | 98 ++++ .../bindings/mfd/realtek,rtl9300-switch.yaml | 115 +++++ .../bindings/power/reset/syscon-reboot.yaml | 11 +- MAINTAINERS | 7 + .../cameo-rtl9302c-2x-rtl8224-2xge.dts | 2 +- arch/mips/boot/dts/realtek/rtl9302c.dtsi | 15 + arch/mips/boot/dts/realtek/rtl930x.dtsi | 29 ++ drivers/i2c/busses/Kconfig | 10 + drivers/i2c/busses/Makefile | 1 + drivers/i2c/busses/i2c-rtl9300.c | 422 ++++++++++++++++++ drivers/power/reset/syscon-reboot.c | 3 +- 11 files changed, 710 insertions(+), 3 deletions(-) create mode 100644 Documentation/devicetree/bindings/i2c/realtek,rtl9300-i2c.yaml create mode 100644 Documentation/devicetree/bindings/mfd/realtek,rtl9300-switch.yaml create mode 100644 arch/mips/boot/dts/realtek/rtl9302c.dtsi create mode 100644 drivers/i2c/busses/i2c-rtl9300.c -- 2.46.2