Re: [PATCH v3 3/4] i2c: jz4780: Use devm_clk_get_enabled() helpers

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Fri, Aug 23, 2024 at 11:51:15AM +0800, Rong Qianfeng wrote:
> The devm_clk_get_enabled() helpers:
>     - call devm_clk_get()
>     - call clk_prepare_enable() and register what is needed in order to
>      call clk_disable_unprepare() when needed, as a managed resource.
> 
> This simplifies the code and avoids the calls to clk_disable_unprepare().
> 
> While at it, no more special handling needed here, remove the goto
> label "err:".

...

>  	ret = of_property_read_u32(pdev->dev.of_node, "clock-frequency",
>  				   &clk_freq);

(side note: this driver should use i2c_timings and respective I2C core
APIs instead of this)

>  	if (ret) {
>  		dev_err(&pdev->dev, "clock-frequency not specified in DT\n");
> -		goto err;
> +		return ret;

While at it,

		return dev_err_probe(...);

>  	}

>  	i2c->speed = clk_freq / 1000;

(side note: this should be HZ_PER_KHZ from units.h)

>  	if (i2c->speed == 0) {
>  		ret = -EINVAL;
>  		dev_err(&pdev->dev, "clock-frequency minimum is 1000\n");
> -		goto err;
> +		return ret;

		return dev_err_probe(...);

>  	}

...

>  	ret = platform_get_irq(pdev, 0);
>  	if (ret < 0)
> -		goto err;
> +		return ret;
>  	i2c->irq = ret;

I would add a blank line here.

>  	ret = devm_request_irq(&pdev->dev, i2c->irq, jz4780_i2c_irq, 0,
>  			       dev_name(&pdev->dev), i2c);
>  	if (ret)
> -		goto err;
> +		return ret;


-- 
With Best Regards,
Andy Shevchenko






[Index of Archives]     [LKML Archive]     [Linux ARM Kernel]     [Linux ARM]     [Git]     [Yosemite News]     [Linux SCSI]     [Linux Hams]

  Powered by Linux