On Fri, May 13, 2022 at 03:33:38AM +0800, 周琰杰 (Zhou Yanjie) wrote: > 1.Add PWM node for X1830 SoC from Ingenic. > 2.Add SSI nodes for X1000 SoC and X1830 SoC from Ingenic. > 3.Refresh SSI related nodes in CU1000-Neo and CU1830-Neo. > 4.The X1830 SoC used by the CU1830-Neo and the X1000 SoC > used by the CU1000-Neo are both single-core processors, > therefore the "OST_CLK_PERCPU_TIMER" ABI should not be > used in the OST nodes of the CU1830-Neo and CU1000-Neo, > it is just a coincidence that there is no problem now. > So replace the misused "OST_CLK_PERCPU_TIMER" ABI with > the correct "OST_CLK_EVENT_TIMER" ABI. > 5.Refresh the defconfig files of the CU1000-Neo board and > the CU1830-Neo board, remove the selection of SPI-GPIO, > and add the selection of SSI. > > 周琰杰 (Zhou Yanjie) (3): > MIPS: Ingenic: Add PWM nodes for X1830. > MIPS: Ingenic: Refresh device tree for Ingenic SoCs and boards. > MIPS: Ingenic: Refresh defconfig for CU1000-Neo and CU1830-Neo. > > arch/mips/boot/dts/ingenic/cu1000-neo.dts | 77 ++++++++++++++++--------------- > arch/mips/boot/dts/ingenic/cu1830-neo.dts | 76 +++++++++++++++--------------- > arch/mips/boot/dts/ingenic/x1000.dtsi | 20 ++++++++ > arch/mips/boot/dts/ingenic/x1830.dtsi | 53 +++++++++++++++++++++ > arch/mips/configs/cu1000-neo_defconfig | 2 +- > arch/mips/configs/cu1830-neo_defconfig | 2 +- > 6 files changed, 154 insertions(+), 76 deletions(-) > > -- > 2.7.4 seried applied to mips-next. Thomas. -- Crap can work. Given enough thrust pigs will fly, but it's not necessarily a good idea. [ RFC1925, 2.3 ]
