Extend the binding to support specifying a different request type for
each direction.
Signed-off-by: Paul Cercueil <paul@xxxxxxxxxxxxxxx>
---
Notes:
v2: Enhance documentation
.../devicetree/bindings/dma/ingenic,dma.yaml | 16 +++++++++++-----
1 file changed, 11 insertions(+), 5 deletions(-)
diff --git a/Documentation/devicetree/bindings/dma/ingenic,dma.yaml b/Documentation/devicetree/bindings/dma/ingenic,dma.yaml
index 2607b403277e..3b0b3b919af8 100644
--- a/Documentation/devicetree/bindings/dma/ingenic,dma.yaml
+++ b/Documentation/devicetree/bindings/dma/ingenic,dma.yaml
@@ -44,13 +44,19 @@ properties:
maxItems: 1
"#dma-cells":
- const: 2
+ enum: [2, 3]
description: >
DMA clients must use the format described in dma.txt, giving a phandle
- to the DMA controller plus the following 2 integer cells:
-
- - Request type: The DMA request type for transfers to/from the
- device on the allocated channel, as defined in the SoC documentation.
+ to the DMA controller plus the following integer cells:
+
+ - Request type: The DMA request type specifies the device endpoint that
+ will be the source or destination of the DMA transfer.
+ If "#dma-cells" is 2, the request type is a single cell, and the
+ direction will be unidirectional (either RX or TX but not both).
+ If "#dma-cells" is 3, the request type has two cells; the first
+ one corresponds to the host to device direction (TX), the second one
+ corresponds to the device to host direction (RX). The DMA channel is
+ then bidirectional.
- Channel: If set to 0xffffffff, any available channel will be allocated
for the client. Otherwise, the exact channel specified will be used.
--
2.33.0
