Hi Zhou,
Zhou Yanjie writes:
>>> diff --git a/drivers/usb/dwc2/params.c b/drivers/usb/dwc2/params.c
>>> index 67c5eb1..a7a1b50 100644
>>> --- a/drivers/usb/dwc2/params.c
>>> +++ b/drivers/usb/dwc2/params.c
>>> @@ -71,6 +71,47 @@ static void dwc2_set_his_params(struct
>>> dwc2_hsotg *hsotg)
>>> p->power_down = DWC2_POWER_DOWN_PARAM_NONE;
>>> }
>>>
>>> +static void dwc2_set_jz4775_params(struct dwc2_hsotg *hsotg)
>>> +{
>>> + struct dwc2_core_params *p = &hsotg->params;
>>> +
>>> + p->otg_cap = DWC2_CAP_PARAM_NO_HNP_SRP_CAPABLE;
>>> + p->speed = DWC2_SPEED_PARAM_HIGH;
>>> + p->phy_type = DWC2_PHY_TYPE_PARAM_UTMI;
>>> + p->phy_utmi_width = 16;
>>> + p->deactivate_ingenic_overcurrent_detection =
>>> + device_property_read_bool(hsotg->dev, "disable-over-current");
>>
>> That device property was not documented in the previous patch. Also
>> this probably should be "ingenic,disable-over-current".
>>
>
> This device property already exists (it has been used in the
> "dwc2_get_device_properties()" function below).
>
> Under normal circumstances, after using this device attribute, it
> should be possible to turn off the overcurrent
>
> detection, but on the Ingenic processors, somehow it did not take
> effect normally, and we must operate the
>
> "VBVALOEN" bit and "VBVALOVAL" bit of "GOTGCTL" register to make it normal.
I believe what Paul is suggesting is that this property lacks
documentation under Documentation/devicetree/bindings/. If that's the
case, you could take the opportunity to document the property and,
perhaps, add the missing prefix.
--
balbi
