Re: [PATCH v4 2/2] MIPS: ingenic: Enable JZ4780_NEMC manually

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 





Le mar. 28 juil. 2020 à 14:00, Krzysztof Kozlowski <krzk@xxxxxxxxxx> a écrit :
On Tue, Jul 28, 2020 at 01:37:02PM +0200, Thomas Bogendoerfer wrote:
 On Tue, Jul 28, 2020 at 01:19:35PM +0200, Krzysztof Kozlowski wrote:
 > On Tue, Jul 28, 2020 at 01:12:11PM +0200, Paul Cercueil wrote:
 > > Hi Krzysztof,
 > >
> > Le mar. 28 juil. 2020 à 12:45, Krzysztof Kozlowski <krzk@xxxxxxxxxx> a écrit
 > > :
> > > The CONFIG_JZ4780_NEMC was previously a default on MIPS but now it has
 > > > to be enabled manually.
 > > >
 > > > Signed-off-by: Krzysztof Kozlowski <krzk@xxxxxxxxxx>
 > >
> > I think you should swap the two so that there are no problems when
 > > bisecting.
 >
> Good point. I was thinking that it will go via some of MIPS trees and > the patch #1 will just wait a cycle. However with acks, I can take it
 > through drivers/memory tree.

 I've acked the patch.

 Thomas.

Thanks but now I noticed that one of changed configs
(arch/mips/configs/rs90_defconfig) is only in MIPS tree.

I think it is easier then to take the patch #2 (configs) via MIPS and
wait with #1 for the next cycle or also take it via MIPS if it applies
cleanly.

Why not take them both in the MIPS tree then? Would that conflict with changes in your tree?

-Paul






[Index of Archives]     [LKML Archive]     [Linux ARM Kernel]     [Linux ARM]     [Git]     [Yosemite News]     [Linux SCSI]     [Linux Hams]

  Powered by Linux