On 02/27/2016 06:21 PM, Niklas Söderlund wrote: > Hi Hans, > > On 2016-02-27 12:32:14 +0100, Hans Verkuil wrote: >> On 02/24/2016 03:58 AM, Niklas Söderlund wrote: >>> A V4L2 driver for Renesas R-Car VIN driver that do not depend on >>> soc_camera. The driver is heavily based on its predecessor and aims to >>> replace it. >>> >>> Signed-off-by: Niklas Söderlund <niklas.soderlund+renesas@xxxxxxxxxxxx> >>> --- >>> >>> The driver is tested on Koelsch and can do streaming using qv4l2 and >>> grab frames using yavta. It passes a v4l2-compliance (git master) run >>> without failures, see bellow for output. Some issues I know about but >>> will have to wait for future work in other patches. >>> - The soc_camera driver provides some pixel formats that do not display >>> properly for me in qv4l2 or yavta. I have ported these formats as is >>> (not working correctly?) to the new driver. >>> - One can not bind/unbind the subdevice and continue using the driver. >>> >>> As stated in commit message the driver is based on its soc_camera >>> version but some features have been drooped (for now?). >>> - The driver no longer try to use the subdev for cropping (using >>> cropcrop/s_crop). >>> - Do not interrogate the subdev using g_mbus_config. >> >> A quick question: was this tested with the adv7180 only? Or do you also >> have access to a sensor to test with? > > I'm not sure I understand your question. I have only tested on Koelsch > with a adv7180 connected to the VIN. But I have had both a NTSC camera > and a PAL Super Nintendo connected to the Koelsch (adv7180). OK, that's what I was looking for. I believe it is possible to connect an external camera sensor as well to the board, so I was just wondering if you had perhaps done that. But that's clearly not the case. No problem, I was just curious. Regards, Hans -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
