On Fri, 2015-09-11 at 22:01 +0200, Torbjorn Jansson wrote:
> On 2015-08-23 19:50, Jurgen Kramer wrote:
> >
> > On Sun, 2015-07-12 at 12:38 +0200, Jurgen Kramer wrote:
> >> I have been running a couple of DVBSky T980C's with CIs with success
> >> using an older kernel (3.17.8) with media-build and some added patches
> >> from the mailing list.
> >>
> >> I thought lets try a current 4.0 kernel to see if I no longer need to be
> >> running a custom kernel. Everything works just fine except the CAM
> >> module. I am seeing these:
> >>
> >> [ 456.574969] dvb_ca adapter 0: Invalid PC card inserted :(
> >> [ 456.626943] dvb_ca adapter 1: Invalid PC card inserted :(
> >> [ 456.666932] dvb_ca adapter 2: Invalid PC card inserted :(
> >>
> >> The normal 'CAM detected and initialised' messages to do show up with
> >> 4.0.8
> >>
> >> I am not sure what changed in the recent kernels, what is needed to
> >> debug this?
> >>
> >> Jurgen
> > Retest. I've isolated one T980C on another PC with kernel 4.1.5, still the same 'Invalid PC card inserted :(' message.
> > Even after installed today's media_build from git no improvement.
> >
> > Any hints where to start looking would be appreciated!
> >
> > cimax2.c|h do not seem to have changed. There are changes to
> > dvb_ca_en50221.c
> >
> > Jurgen
> >
>
> did you get it to work?
No, it needs a thorough debug session. So far no one seems able to
help...
> i got a dvbsky T980C too for dvb-t2 reception and so far the only
> drivers that have worked at all is the ones from dvbsky directly.
>
> i was very happy when i noticed that recent kernels have support for it
> built in but unfortunately only the modules and firmware loads but then
> nothing actually works.
> i use mythtv and it complains a lot about the signal, running femon also
> produces lots of errors.
>
> so i had to switch back to kernel 4.0.4 with mediabuild from dvbsky.
>
> if there were any other dvb-t2 card with ci support that had better
> drivers i would change right away.
>
> one problem i have with the mediabuilt from dvbsky is that at boot the
> cam never works and i have to first tune a channel, then remove and
> reinstert the cam to get it to work.
> without that nothing works.
>
> and finally a problem i ran into when i tried mediabuilt from linuxtv.org.
> fedora uses kernel modules with .ko.xz extension so when you install the
> mediabuilt modulels you get one modulename.ko and one modulename.ko.xz
>
> before a make install from mediabuild overwrote the needed modules.
> any advice on how to handle this now?
>
>
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
