On 07/16/2015 09:04 AM, Antti Palosaari wrote:
> HackRF SDR device has both receiver and transmitter. There is limitation
> that receiver and transmitter cannot be used at the same time
> (half-duplex operation). That patch implements transmitter support to
> existing receiver only driver.
>
> Cc: Hans Verkuil <hverkuil@xxxxxxxxx>
> Signed-off-by: Antti Palosaari <crope@xxxxxx>
> ---
> drivers/media/usb/hackrf/hackrf.c | 787 +++++++++++++++++++++++++++-----------
> 1 file changed, 572 insertions(+), 215 deletions(-)
>
> @@ -611,8 +751,15 @@ static int hackrf_queue_setup(struct vb2_queue *vq,
> unsigned int *nplanes, unsigned int sizes[], void *alloc_ctxs[])
> {
> struct hackrf_dev *dev = vb2_get_drv_priv(vq);
> + struct usb_interface *intf = dev->intf;
> + int ret;
>
> - dev_dbg(dev->dev, "nbuffers=%d\n", *nbuffers);
> + dev_dbg(&intf->dev, "nbuffers=%d\n", *nbuffers);
> +
> + if (test_and_set_bit(QUEUE_SETUP, &dev->flags)) {
> + ret = -EBUSY;
> + goto err;
> + }
This doesn't work. The bit is only cleared when start_streaming fails or
stop_streaming is called. But the application can also call REQBUFS again
or just close the file handle, and then QUEUE_SETUP should also be cleared.
But why is this here in the first place? It doesn't seem to do anything
useful (except mess up the v4l2-compliance tests).
I've removed it and it now seems to work OK.
Regards,
Hans
>
> /* Need at least 8 buffers */
> if (vq->num_buffers + *nbuffers < 8)
> @@ -620,8 +767,11 @@ static int hackrf_queue_setup(struct vb2_queue *vq,
> *nplanes = 1;
> sizes[0] = PAGE_ALIGN(dev->buffersize);
>
> - dev_dbg(dev->dev, "nbuffers=%d sizes[0]=%d\n", *nbuffers, sizes[0]);
> + dev_dbg(&intf->dev, "nbuffers=%d sizes[0]=%d\n", *nbuffers, sizes[0]);
> return 0;
> +err:
> + dev_dbg(&intf->dev, "failed=%d\n", ret);
> + return ret;
> }
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
