The board has multiple "chips", each of which are detected and
configured as part of the driver loading.
saa7164
This chip requires firmware which appears to load correctly at 20.240637
si2168
This chip requires firmware
The chip is detected and "loaded" but the chip version is not
identified, so the firmware load does not occur.
As this is a dual tuner card, there are 2 of these chips.
si2157
this is the actual tuner chip, again there are 2 chips on the card, and
it does not need to load any firmware.
The firmware version already in the chip is reported at 165512.480559
and 165518.024867
both of the si21xx chips don't get the firmware loaded until the tuner
is accessed by an application, so the card appears to be loading
correctly, but will not tune.
See my other post for a workaround.
I'm sure one of the developers will provide a more elegant/correct
solution soon.
Regards
Peter
On 04/06/2015 12:38 pm, Stephen Allan wrote:
Hi,
Just thought I'd clarify that in my case I haven't ever used this
board with Windows. See a more detailed dmesg output below for
"saa7168" and "si21xx" messages. From what I am seeing the firmware
is loading correctly. However I may be wrong.
dmesg | grep 'saa7164\|si21'
[ 18.112439] saa7164 driver loaded
[ 18.113429] CORE saa7164[0]: subsystem: 0070:f120, board: Hauppauge
WinTV-HVR2205 [card=13,autodetected]
[ 18.113435] saa7164[0]/0: found at 0000:03:00.0, rev: 129, irq: 16,
latency: 0, mmio: 0xf7800000
[ 18.113470] saa7164 0000:03:00.0: irq 46 for MSI/MSI-X
[ 18.270310] saa7164_downloadfirmware() no first image
[ 18.270322] saa7164_downloadfirmware() Waiting for firmware upload
(NXP7164-2010-03-10.1.fw)
[ 20.240635] saa7164_downloadfirmware() firmware read 4019072 bytes.
[ 20.240637] saa7164_downloadfirmware() firmware loaded.
[ 20.240642] saa7164_downloadfirmware() SecBootLoader.FileSize =
4019072
[ 20.240648] saa7164_downloadfirmware() FirmwareSize = 0x1fd6
[ 20.240649] saa7164_downloadfirmware() BSLSize = 0x0
[ 20.240650] saa7164_downloadfirmware() Reserved = 0x0
[ 20.240650] saa7164_downloadfirmware() Version = 0x1661c00
[ 27.096269] saa7164_downloadimage() Image downloaded, booting...
[ 27.200300] saa7164_downloadimage() Image booted successfully.
[ 29.936962] saa7164_downloadimage() Image downloaded, booting...
[ 31.705407] saa7164_downloadimage() Image booted successfully.
[ 31.750358] saa7164[0]: Hauppauge eeprom: model=151609
[ 31.776446] si2168 22-0064: Silicon Labs Si2168 successfully
attached
[ 31.781307] si2157 20-0060: Silicon Labs Si2147/2148/2157/2158
successfully attached
[ 31.781695] DVB: registering new adapter (saa7164)
[ 31.781698] saa7164 0000:03:00.0: DVB: registering adapter 4
frontend 0 (Silicon Labs Si2168)...
[ 31.782652] si2168 22-0066: Silicon Labs Si2168 successfully
attached
[ 31.785961] si2157 21-0060: Silicon Labs Si2147/2148/2157/2158
successfully attached
[ 31.786340] DVB: registering new adapter (saa7164)
[ 31.786342] saa7164 0000:03:00.0: DVB: registering adapter 5
frontend 0 (Silicon Labs Si2168)...
[ 31.786562] saa7164[0]: registered device video1 [mpeg]
[ 32.021659] saa7164[0]: registered device video2 [mpeg]
[ 32.238336] saa7164[0]: registered device vbi0 [vbi]
[ 32.238389] saa7164[0]: registered device vbi1 [vbi]
[165512.436662] si2168 22-0066: unknown chip version Si2168-
[165512.450315] si2157 21-0060: found a 'Silicon Labs Si2157-A30'
[165512.480559] si2157 21-0060: firmware version: 3.0.5
[165517.981155] si2168 22-0064: unknown chip version Si2168-
[165517.994620] si2157 20-0060: found a 'Silicon Labs Si2157-A30'
[165518.024867] si2157 20-0060: firmware version: 3.0.5
[165682.334171] si2168 22-0064: unknown chip version Si2168-
[165730.579085] si2168 22-0064: unknown chip version Si2168-
[165838.420693] si2168 22-0064: unknown chip version Si2168-
[166337.342437] si2168 22-0064: unknown chip version Si2168-
[167305.393572] si2168 22-0064: unknown chip version Si2168-
[170762.907071] si2168 22-0064: unknown chip version Si2168-
-----Original Message-----
From: Antti Palosaari [mailto:crope@xxxxxx]
Sent: Wednesday, June 3, 2015 6:03 PM
To: Stephen Allan; linux-media@xxxxxxxxxxxxxxx
Subject: Re: Hauppauge WinTV-HVR2205 driver feedback
On 06/03/2015 10:55 AM, Antti Palosaari wrote:
On 06/03/2015 06:55 AM, Stephen Allan wrote:
I am aware that there is some development going on for the saa7164
driver to support the Hauppauge WinTV-HVR2205. I thought I would
post some feedback. I have recently compiled the driver as at
2015-05-31 using "media build tree". I am unable to tune a channel.
When running the following w_scan command:
w_scan -a4 -ft -cAU -t 3 -X > /tmp/tzap/channels.conf
I get the following error after scanning the frequency range for
Australia.
ERROR: Sorry - i couldn't get any working frequency/transponder
Nothing to scan!!
At the same time I get the following messages being logged to the
Linux console.
dmesg
[165512.436662] si2168 22-0066: unknown chip version Si2168-
[165512.450315] si2157 21-0060: found a 'Silicon Labs Si2157-A30'
[165512.480559] si2157 21-0060: firmware version: 3.0.5
[165517.981155] si2168 22-0064: unknown chip version Si2168-
[165517.994620] si2157 20-0060: found a 'Silicon Labs Si2157-A30'
[165518.024867] si2157 20-0060: firmware version: 3.0.5
[165682.334171] si2168 22-0064: unknown chip version Si2168-
[165730.579085] si2168 22-0064: unknown chip version Si2168-
[165838.420693] si2168 22-0064: unknown chip version Si2168-
[166337.342437] si2168 22-0064: unknown chip version Si2168-
[167305.393572] si2168 22-0064: unknown chip version Si2168-
Many thanks to the developers for all of your hard work.
Let me guess they have changed Si2168 chip to latest "C" version.
Driver supports only A and B (A20, A30 and B40). I have never seen C
version.
gah, looking the driver I think that is not issue - it will likely
print "unknown chip version Si2168-C.." on that case already. However,
I remember I have seen that kind of issue earlier too, but don't
remember what was actual reason. Probably something to do with
firmware, wrong firmware and loading has failed? Could you make cold
boot, remove socket from the wallet and wait minute it really powers
down, then boot and look what happens.
regards
Antti
--
http://palosaari.fi/
N�����r��y���b�X��ǧv�^�){.n�+����{���b�{ay� ʇڙ�,j��f���h���z� �w����+zf���h���~����i���z� �w���?����&�)ߢ
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
