There is no need to do software reset on init() as it is done a bit later on end of set_frontend(). Software reset usually means restarting (resetting to starting point) chip internal state machine (FSM). Naturally it is done after all parameters are programmed. Signed-off-by: Antti Palosaari <crope@xxxxxx> --- drivers/media/dvb-frontends/rtl2832.c | 15 --------------- 1 file changed, 15 deletions(-) diff --git a/drivers/media/dvb-frontends/rtl2832.c b/drivers/media/dvb-frontends/rtl2832.c index 4b6e6e0..82398d8 100644 --- a/drivers/media/dvb-frontends/rtl2832.c +++ b/drivers/media/dvb-frontends/rtl2832.c @@ -434,21 +434,6 @@ static int rtl2832_init(struct dvb_frontend *fe) goto err; } - /* - * r820t NIM code does a software reset here at the demod - - * may not be needed, as there's already a software reset at - * set_params() - */ -#if 1 - /* soft reset */ - ret = rtl2832_wr_demod_reg(dev, DVBT_SOFT_RST, 0x1); - if (ret) - goto err; - - ret = rtl2832_wr_demod_reg(dev, DVBT_SOFT_RST, 0x0); - if (ret) - goto err; -#endif /* init stats here in order signal app which stats are supported */ c->strength.len = 1; c->strength.stat[0].scale = FE_SCALE_NOT_AVAILABLE; -- http://palosaari.fi/ -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
