On some hardware (au0828/au8522), the hardware is broken with
regards to the initial pulse detection. So, the driver needs to
produce a fake start pulse. That limits the acceptable protocols,
as it is not possible to produce a fake pulse that would cover
all supported protocols.
So, allow the driver to explicitly set the allowed protocols.
If the driver doesn't specify, keep the old behavior.
Signed-off-by: Mauro Carvalho Chehab <m.chehab@xxxxxxxxxxx>
---
drivers/media/rc/rc-main.c | 5 ++---
1 file changed, 2 insertions(+), 3 deletions(-)
diff --git a/drivers/media/rc/rc-main.c b/drivers/media/rc/rc-main.c
index dfceeb4e34a8..a7991c7d010a 100644
--- a/drivers/media/rc/rc-main.c
+++ b/drivers/media/rc/rc-main.c
@@ -859,10 +859,9 @@ static ssize_t show_protocols(struct device *device,
if (fattr->type == RC_FILTER_NORMAL) {
enabled = dev->enabled_protocols;
- if (dev->raw)
+ allowed = dev->allowed_protocols;
+ if (dev->raw && !allowed)
allowed = ir_raw_get_allowed_protocols();
- else
- allowed = dev->allowed_protocols;
} else {
enabled = dev->enabled_wakeup_protocols;
allowed = dev->allowed_wakeup_protocols;
--
1.9.3
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
