On 04/11/2014 03:03 PM, Hans Verkuil wrote:
> On 04/11/2014 02:48 PM, Tomasz Stanislawski wrote:
>> On 04/07/2014 03:11 PM, Hans Verkuil wrote:
>>> From: Hans Verkuil <hans.verkuil@xxxxxxxxx>
>>>
>>> The videobuf2-core did not zero the 'planes' array in __qbuf_userptr()
>>> and __qbuf_dmabuf(). That's now memset to 0. Without this the reserved
>>> array in struct v4l2_plane would be non-zero, causing v4l2-compliance
>>> errors.
>>>
>>> More serious is the fact that data_offset was not handled correctly:
>>>
>>> - for capture devices it was never zeroed, which meant that it was
>>> uninitialized. Unless the driver sets it it was a completely random
>>> number. With the memset above this is now fixed.
>>>
>>> - __qbuf_dmabuf had a completely incorrect length check that included
>>> data_offset.
>>
>> Hi Hans,
>>
>> I may understand it wrongly but IMO allowing non-zero data offset
>> simplifies buffer sharing using dmabuf.
>> I remember a problem that occurred when someone wanted to use
>> a single dmabuf with multiplanar API.
>>
>> For example, MFC shares a buffer with DRM. Assume that DRM device
>> forces the whole image to be located in one dmabuf.
>>
>> The MFC uses multiplanar API therefore application must use
>> the same dmabuf to describe luma and chroma planes.
>>
>> It is intuitive to use the same dmabuf for both planes and
>> data_offset=0 for luma plane and data_offset = luma_size
>> for chroma offset.
>>
>> The check:
>>
>>> - if (planes[plane].length < planes[plane].data_offset +
>>> - q->plane_sizes[plane]) {
>>
>> assured that the logical plane does not overflow the dmabuf.
>>
>> Am I wrong?
>
> Yes :-)
>
> For video capture the data_offset field is set by the *driver*, not the
> application. In practice data_offset is the size of a header that is in
> front of the actual image.
>
> You cannot use data_offset for the purpose you describe. To do that a new
> offset field would have to be added (user_offset?). I'm not opposed to
> that, I think it is a valid use-case for both dmabuf and userptr and
> even mmap in combination with CREATE_BUFS.
Ok. What do you think about allowing the user to set this field?
The driver would be allowed to adjust it.
This is a slight change of semantics. As long as application
was forced to treat data_offset as a reserved field (I mean zeroing)
then this change would be backward compatible.
Otherwise, a new field could be introduces as you mentioned.
The name buffer_offset or simply offset might be more
appropriate than user_offset.
I can prepare some RFC about this extension.
Regards,
Tomasz Stanislawski
>
> Regards,
>
> Hans
>
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
