Add the fimc-is node and the required pinctrl nodes for
fimc-is driver for Exynos5. Also adds the DT binding documentation
for the new fimc-is node.
Signed-off-by: Arun Kumar K <arun.kk@xxxxxxxxxxx>
Signed-off-by: Kilyeon Im <kilyeon.im@xxxxxxxxxxx>
---
.../devicetree/bindings/media/soc/exynos5-is.txt | 81 ++++++++++++++++++++
arch/arm/boot/dts/exynos5250-pinctrl.dtsi | 60 +++++++++++++++
arch/arm/boot/dts/exynos5250-smdk5250.dts | 54 ++++++++++++-
arch/arm/boot/dts/exynos5250.dtsi | 8 ++
4 files changed, 201 insertions(+), 2 deletions(-)
create mode 100644 Documentation/devicetree/bindings/media/soc/exynos5-is.txt
mode change 100644 => 100755 arch/arm/boot/dts/exynos5250-smdk5250.dts
mode change 100644 => 100755 arch/arm/boot/dts/exynos5250.dtsi
diff --git a/Documentation/devicetree/bindings/media/soc/exynos5-is.txt b/Documentation/devicetree/bindings/media/soc/exynos5-is.txt
new file mode 100644
index 0000000..e0fdf02
--- /dev/null
+++ b/Documentation/devicetree/bindings/media/soc/exynos5-is.txt
@@ -0,0 +1,81 @@
+Samsung EXYNOS SoC Camera Subsystem
+-----------------------------------
+
+The camera subsystem on Samsung Exynos5 SoC has some changes relative
+to previous SoC versions. Exynos5 has almost similar MIPI-CSIS and
+FIMC-LITE IPs but removed the FIMC-CAPTURE. Instead it has an improved
+FIMC-IS which can provide imate data DMA output.
+
+The device tree binding remain similar to the Exynos4 bindings which can
+be seen at samsung-fimc.txt with the addition of fimc-is sub-node which will
+be explained here.
+
+fimc-is subnode of camera node
+------------------------------
+
+Required properties:
+
+- compatible : must be "samsung,exynos5250-fimc-is"
+- reg : physical base address and size of the memory mapped
+ registers
+- interrupt-parent : Parent interrupt controller
+- interrupts : fimc-is interrupt to the parent combiner
+
+Board specific properties:
+
+- pinctrl-names : pinctrl names for camera port pinmux control, at least
+ "default" needs to be specified.
+- pinctrl-0...N : pinctrl properties corresponding to pinctrl-names
+
+Sensor sub-nodes:
+
+FIMC-IS IP supports custom built sensors to be controlled exclusively by
+the FIMC-IS firmware. These sensor properties are to be defined here.
+Sensor nodes are described in the same way as in generic sensors used in
+Exynos4 and described in samsung-fimc.txt.
+
+Example:
+
+SoC common node:
+
+ fimc_is: fimc-is@13000000 {
+ compatible = "samsung,exynos5250-fimc-is";
+ reg = <0x13000000 0x200000>;
+ interrupt-parent = <&combiner>;
+ interrupts = <19 1>;
+ status = "disabled";
+ };
+
+Board specific node:
+
+ fimc-is@13000000 {
+ status = "okay";
+ pinctrl-0 =
+ <&cam_port_a_clk_active
+ &cam_bayer_clk_active
+ &isp_uart
+ &cam_i2c0
+ &cam_i2c1>;
+ pinctrl-names = "default";
+ s5k4e5 {
+ compatible = "samsung,s5k4e5";
+ gpios = <&gpx1 2 1>;
+ clock-frequency = <24000000>;
+ port {
+ is_s5k4e5_ep: endpoint {
+ remote-endpoint = <&csis0_ep>;
+ };
+ };
+ };
+ s5k6a3 {
+ compatible = "samsung,s5k6a3";
+ gpios = <&gpx1 0 1>;
+ clock-frequency = <24000000>;
+ port {
+ is_s5k6a3_ep: endpoint {
+ remote-endpoint = <&csis1_ep>;
+ };
+ };
+ };
+ };
+
diff --git a/arch/arm/boot/dts/exynos5250-pinctrl.dtsi b/arch/arm/boot/dts/exynos5250-pinctrl.dtsi
index 3caaa21..320c22b 100644
--- a/arch/arm/boot/dts/exynos5250-pinctrl.dtsi
+++ b/arch/arm/boot/dts/exynos5250-pinctrl.dtsi
@@ -556,6 +556,38 @@
};
pinctrl@13400000 {
+ gpe1: gpe1 {
+ gpio-controller;
+ #gpio-cells = <2>;
+
+ interrupt-controller;
+ #interrupt-cells = <2>;
+ };
+
+ gpf0: gpf0 {
+ gpio-controller;
+ #gpio-cells = <2>;
+
+ interrupt-controller;
+ #interrupt-cells = <2>;
+ };
+
+ gpf1: gpf1 {
+ gpio-controller;
+ #gpio-cells = <2>;
+
+ interrupt-controller;
+ #interrupt-cells = <2>;
+ };
+
+ gpg2: gpg2 {
+ gpio-controller;
+ #gpio-cells = <2>;
+
+ interrupt-controller;
+ #interrupt-cells = <2>;
+ };
+
gph0: gph0 {
gpio-controller;
#gpio-cells = <2>;
@@ -594,6 +626,34 @@
samsung,pin-pud = <0>;
samsung,pin-drv = <0>;
};
+
+ cam_bayer_clk_active: cam-bayer-clk-active {
+ samsung,pins = "gpg2-1";
+ samsung,pin-function = <2>;
+ samsung,pin-pud = <0>;
+ samsung,pin-drv = <3>;
+ };
+
+ isp_uart: isp-uart {
+ samsung,pins = "gpe1-0", "gpe1-1";
+ samsung,pin-function = <3>;
+ samsung,pin-pud = <0>;
+ samsung,pin-drv = <3>;
+ };
+
+ cam_i2c0: cam-i2c0 {
+ samsung,pins = "gpf0-0", "gpf0-1";
+ samsung,pin-function = <2>;
+ samsung,pin-pud = <0>;
+ samsung,pin-drv = <3>;
+ };
+
+ cam_i2c1: cam-i2c1 {
+ samsung,pins = "gpf0-2", "gpf0-3";
+ samsung,pin-function = <2>;
+ samsung,pin-pud = <0>;
+ samsung,pin-drv = <3>;
+ };
};
pinctrl_3: pinctrl@03680000 {
diff --git a/arch/arm/boot/dts/exynos5250-smdk5250.dts b/arch/arm/boot/dts/exynos5250-smdk5250.dts
old mode 100644
new mode 100755
index 356e014..0a2da64
--- a/arch/arm/boot/dts/exynos5250-smdk5250.dts
+++ b/arch/arm/boot/dts/exynos5250-smdk5250.dts
@@ -92,6 +92,7 @@
m5mols@1f {
compatible = "fujitsu,m-5mols";
+ status = "disabled";
reg = <0x1F>;
gpios = <&gpx3 3 0xf>, <&gpx1 2 1>;
clock-frequency = <24000000>;
@@ -242,7 +243,7 @@
csis_0: csis@13C20000 {
status = "okay";
- clock-frequency = <166000000>;
+ clock-frequency = <267000000>; /* s5k4e5 */
#address-cells = <1>;
#size-cells = <0>;
@@ -250,7 +251,7 @@
port@3 {
reg = <3>;
csis0_ep: endpoint {
- remote-endpoint = <&m5mols_ep>;
+ remote-endpoint = <&is_s5k4e5_ep>;
data-lanes = <1 2 3 4>;
samsung,csis-hs-settle = <12>;
samsung,csis-wclk;
@@ -258,5 +259,54 @@
};
};
+ csis_1: csis@13C30000 {
+ status = "okay";
+ clock-frequency = <160000000>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ /* Camera D (4) MIPI CSI-2 (CSIS1) */
+ port@4 {
+ reg = <4>;
+ csis1_ep: endpoint {
+ remote-endpoint = <&is_s5k6a3_ep>;
+ data-lanes = <1>;
+ samsung,csis-hs-settle = <18>;
+ samsung,csis-wclk;
+ };
+ };
+ };
+
+ fimc-is@13000000 {
+ status = "okay";
+ pinctrl-0 =
+ <&cam_port_a_clk_active
+ &cam_bayer_clk_active
+ &isp_uart
+ &cam_i2c0
+ &cam_i2c1>;
+ pinctrl-names = "default";
+ s5k4e5 {
+ compatible = "samsung,s5k4e5";
+ gpios = <&gpx1 2 1>;
+ clock-frequency = <24000000>;
+ port {
+ is_s5k4e5_ep: endpoint {
+ remote-endpoint = <&csis0_ep>;
+ };
+ };
+ };
+ s5k6a3 {
+ compatible = "samsung,s5k6a3";
+ gpios = <&gpx1 0 1>;
+ clock-frequency = <24000000>;
+ port {
+ is_s5k6a3_ep: endpoint {
+ remote-endpoint = <&csis1_ep>;
+ };
+ };
+ };
+ };
+
};
};
diff --git a/arch/arm/boot/dts/exynos5250.dtsi b/arch/arm/boot/dts/exynos5250.dtsi
old mode 100644
new mode 100755
index 564c05f..e18df49
--- a/arch/arm/boot/dts/exynos5250.dtsi
+++ b/arch/arm/boot/dts/exynos5250.dtsi
@@ -410,5 +410,13 @@
bus-width = <2>;
status = "disabled";
};
+
+ fimc_is: fimc-is@13000000 {
+ compatible = "samsung,exynos5250-fimc-is";
+ reg = <0x13000000 0x200000>;
+ interrupt-parent = <&combiner>;
+ interrupts = <19 1>;
+ status = "disabled";
+ };
};
};
--
1.7.9.5
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
