Hi,
On 02/11/2013 02:21 PM, Hans Verkuil wrote:
On Mon February 11 2013 14:08:44 Hans de Goede wrote:
Hi,
Subject: stk-webcam: the initial hflip and vflip setup was the wrong way around
No it is not.
You are right, that patch makes no sense. It was a long day :-)
On 02/10/2013 06:52 PM, Hans Verkuil wrote:
From: Hans Verkuil <hans.verkuil@xxxxxxxxx>
This resulted in an upside-down picture.
No it does not, the laptop having an upside down mounted camera and not being
in the dmi-table is what causes an upside down picture. For a non upside
down camera (so no dmi-match) hflip and vflip should be 0.
The fix for the upside-down-ness Arvydas Sidorenko reported would be to
add his laptop to the upside down table.
That doesn't make sense either. Arvydas, it worked fine for you before, right?
Yes, it probably worked before, but not with...
That is, if you use e.g. v3.8-rc7 then your picture is the right side up.
3.8 will show it upside down for Arvydas
The story goes likes this:
1) Once upon a time the stkwebcam driver was written
2) The webcam in question was used mostly in Asus laptop models, including
the laptop of the original author of the driver, and in these models, in
typical Asus fashion (see the long long list for uvc cams inside v4l-utils),
they mounted the webcam-module the wrong way up. So the hflip and vflip
module options were given a default value of 1 (the correct value for
upside down mounted models)
3) Years later I got a bug report from a user with a laptop with stkwebcam,
where the module was actually mounted the right way up, and thus showed upside
down under Linux. So now I was facing the choice of 2 options:
a) Add a not-upside-down list to stkwebcam, which overrules the default
b) Do it like all the other drivers do, and make the default right for
cams mounted the proper way and add an upside-down model list, with models
where we need to flip-by-default.
Despite knowing that going b) would cause a period of pain where we were
building the table (ie what we're discussing now) I opted to go for option
b), since a) is just too ugly, and worse different from how every other
driver does it leading to confusion in the long run.
IOW this is entirely my fault, and I take full responsibility for it.
Arvydas, can you please run "sudo dmidecode > dmi.log", and send me or
Hans V. the generated dmi.log file? Then we can add your laptop to the
upside-down model list.
Regards,
Hans
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
