I know that they are not that powerful. I don't want to dump the whole transportstream but just a single program (~ 10 mbit/s) contained in it. Filtering based on the PID is done in the device isn't it? Ingo 2012/11/27 Joel Wirāmu Pauling <joel@xxxxxxxxxxxx>: > The 1043nd and similar ar7xxx chipsets only support around 30-40bit > transfers across the CPU and chip-set bus. > > I would be very surprised if you could reliably put an mpeg2 stream on the > wire from them. > > > -Joel > > http://gplus.to/aenertia > http://linkedin.com/in/aenertia > @aenertia > > > > > On 27 November 2012 06:50, Ingo Kofler <ingo.kofler@xxxxxxxxx> wrote: >> >> Hi, >> >> I am trying to get my PCTV DVB-S2 stick running on my TP-Link >> TL-WR1043ND that runs OpenWrt (Attitude Adjustment Beta, Kernel >> 3.3.8). I have cross-compiled the corresponding kernel modules and >> deployed them on the router. I have also deployed the firmware on the >> device. >> >> After loading the corresponding modules the /dev/dvb/... devices show >> up and the dmesg output seems to be fine. Then I tried to test the >> device using szap and a channels.conf file. Unfortunately, the device >> cannot tune to most of the transponders except of two. Both are >> located in the vertical high band of the Astra 19E. For all other >> transponders I do not get a lock of the frontend. >> >> Tuning works fine on my PC using kernel verions 3.2 and 3.5 (the ones >> that ship with Ubuntu) and using the same channels.conf file and >> stick. So I conclude that both the stick, the satellite dish and the >> channels.conf is working. I've also tested it on the router board with >> an external powered USB Hub (I though that maybe the power of the >> router's USB port wasn't good enough). >> >> Now I have no further ideas. Before I start to debug the C code and >> try to figure out the difference between the PC and the router - Are >> there any known issues with this driver? Does it work on MIPS and >> different endianess? >> >> Best regards, >> Ingo >> -- >> To unsubscribe from this list: send the line "unsubscribe linux-media" in >> the body of a message to majordomo@xxxxxxxxxxxxxxx >> More majordomo info at http://vger.kernel.org/majordomo-info.html > > -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
