Em 06-08-2012 09:21, Antti Palosaari escreveu: > On 08/05/2012 08:44 PM, Mauro Carvalho Chehab wrote: >> The dvb-usb-v2 core doesn't know anything about CI. So, the >> driver needs to handle it by hand. This patch stops CI just >> before stopping URB's/RC, and restarts it before URB/RC start. >> >> It should be noticed that suspend/resume is not yet working properly, >> as the PM model requires the implementation of reset_resume: >> dvb_usb_az6007 1-6:1.0: no reset_resume for driver dvb_usb_az6007? >> But this is not implemented there at dvb-usb-v2 yet. > > That is true, but it is coming: > http://blog.palosaari.fi/2012/07/dvb-power-management-on-suspend.html > http://git.linuxtv.org/anttip/media_tree.git/shortlog/refs/heads/dvb_core3 > > At the time I added initial suspend/resume support for dvb-usb-v2 I left those out purposely as I saw some study and changes are needed for DVB-core/frontend. > > Normally suspend keeps USB-device powered and calls .resume() on resume. But on certain conditions USB device could lose power > during suspend and on that case reset_resume() is called, and if there is no reset_resume() is calls disconnect() (and probe() after that). This should depend on BIOS settings, and what of the following type of suspend[1] was done: S1: All processor caches are flushed, and the CPU(s) stops executing instructions. Power to the CPU(s) and RAM is maintained; devices that do not indicate they must remain on may be powered down. S2: CPU powered off. Dirty cache is flushed to RAM. S3: Commonly referred to as Standby, Sleep, or Suspend to RAM. RAM remains powered S4: Hibernation or Suspend to Disk. All content of main memory is saved to non-volatile memory such as a hard drive, and is powered down. [1] http://en.wikipedia.org/wiki/Advanced_Configuration_and_Power_Interface There are also some per-device sysfs nodes that control how PM will work for them. See: $ tree /sys/devices/pci0000:00/0000:00:1d.7/usb1/1-8/dvb/dvb0.frontend0 /sys/devices/pci0000:00/0000:00:1d.7/usb1/1-8/dvb/dvb0.frontend0 ├── dev ├── device -> ../../../1-8 ├── power │ ├── async │ ├── autosuspend_delay_ms │ ├── control │ ├── runtime_active_kids │ ├── runtime_active_time │ ├── runtime_enabled │ ├── runtime_status │ ├── runtime_suspended_time │ └── runtime_usage ├── subsystem -> ../../../../../../../class/dvb └── uevent There are a number of pm functions that can change the power management behavior as well. Not sure how to control it, but, IMHO, for a media device, it only makes sense to keep it powered on suspend if the device has IR and if the power button of the IR could be used to wake up the hardware. Otherwise, the better is to just power it off, to save battery (for notebooks). Maybe it makes sense to talk with Raphael Wysocki to be sure that it will cover all possible cases: auto-suspend, S1/S2/S3/S4 and "wake on IR"). > regards > Antti -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
