On 06/14/2012 04:15 AM, Antti Palosaari wrote:
On 06/14/2012 03:44 AM, Malcolm Priestley wrote:
On Thu, 2012-06-14 at 02:29 +0300, Antti Palosaari wrote:
Hi Malcolm,
I was really surprised someone has had interest to test that stuff at
that phase as I did not even advertised it yet :) It is likely happen
next Monday or so as there is some issues I would like to check / solve.
On 06/14/2012 01:24 AM, Malcolm Priestley wrote:
Hi antti
There some issues with dvb_usb_v2 with the lmedm04 driver.
The first being this patch, no return value from
dvb_usb_download_firmware
causes system wide dead lock with COLD disconnect as system attempts
to continue
to warm state.
Hmm, I did not understand what you mean. What I looked lmedm04 driver I
think it uses single USB ID (no cold + warm IDs). So it downloads
firmware and then reconnects itself from the USB bus?
For that scenario you should "return RECONNECTS_USB;" from the driver
.download_firmware().
If the device disconnects from the USB bus after the firmware download.
In most cases the device is already gone.
There is currently no way to insert RECONNECTS_USB into the return.
Argh, I was blind! You are absolutely correct. It never returns value 1
(RECONNECTS_USB) from the .download_firmware().
That patch is fine, I will apply it, thanks!
I think that must be also changed to return immediately without
releasing the interface. Let the USB core release it when it detects
disconnect - otherwise it could crash as it tries to access potentially
resources that are already freed. Just for the timing issue if it
happens or not.
} else if (ret == RECONNECTS_USB) {
ret = 0;
goto exit_usb_driver_release_interface;
add return 0 here without releasing interface and test.
I tested it using one non-public Cypress FX2 device - it was changing
USB ID after the FX download, but from the driver perspective it does
not matter. It is always new device if it reconnects USB.
Have double checked that the thread is not continuing to write on the
old ID?
Nope, but likely delayed probe() is finished until it reconnects so I
cannot see problem. You device disconnects faster and thus USB core
traps .disconnect() earlier...
Could you test returning 0 and if it works sent new patch.
The zero condition will lead to dvb_usb_init.
PS. as I looked that driver I saw many different firmwares. That is now
supported and you should use .get_firmware_name() (maybe you already did
it).
Yes, I have supported this in the driver.
Malcolm,
could you just test if returning from the routines after fw download is
enough to fix all your problems?
I mean those two fixes:
dvb_usb_download_firmware()
* return RECONNECTS_USB correctly
dvb_usbv2_init_work()
* return without releasing USB interface if RECONNECTS_USB
regardss
Antti
--
http://palosaari.fi/
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
