Thanks Andy. Again I'm a n00b, thus, can you point me to a page or resource where I can find and install i2c_algo_bit? Thanks again, H -----Original Message----- From: Andy Walls [mailto:awalls@xxxxxxxxxxxxxxxx] Sent: May-05-12 8:43 PM To: Hector Catre; linux-media@xxxxxxxxxxxxxxx Subject: Re: error - cx18 driver Hector Catre <hcatre@xxxxxxxxx> wrote: >Note: I’m a relatively n00b trying to set up mythtv and having issues >installing the hauppage hvr-1600 tuner/capture card. > >When I run dmesg, I get the following: > >[ 117.013178] a1ac5dc28d2b4ca78e183229f7c595ffd725241c [media] gspca >- sn9c20x: Change the exposure setting of Omnivision sensors [ >117.013183] 4fb8137c43ebc0f5bc0dde6b64faa9dd1b1d7970 [media] gspca >- sn9c20x: Don't do sensor update before the capture is started [ >117.013188] c4407fe86d3856f60ec711e025bbe9a0159354a3 [media] gspca >- sn9c20x: Set the i2c interface speed >[ 117.028665] cx18: Unknown symbol i2c_bit_add_bus (err 0) > >Help. > >Thanks, >H >-- >To unsubscribe from this list: send the line "unsubscribe linux-media" >in >the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info >at http://vger.kernel.org/majordomo-info.html You must ensure i2c_algo_bit.ko exists as a kernel module or that i2c_algo_bit is built into your kernel. Regards, Andy -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
