From: Hans Verkuil <hans.verkuil@xxxxxxxxx> These new ioctls make it possible for the dv_timings API to replace the dv_preset API eventually. Signed-off-by: Hans Verkuil <hans.verkuil@xxxxxxxxx> Reviewed-by: Mauro Carvalho Chehab <mchehab@xxxxxxxxxx> --- include/linux/videodev2.h | 173 ++++++++++++++++++++++++++++++++++++++------- 1 file changed, 149 insertions(+), 24 deletions(-) diff --git a/include/linux/videodev2.h b/include/linux/videodev2.h index 5a09ac3..6062c57 100644 --- a/include/linux/videodev2.h +++ b/include/linux/videodev2.h @@ -986,29 +986,56 @@ struct v4l2_dv_enum_preset { * D V B T T I M I N G S */ -/* BT.656/BT.1120 timing data */ +/** struct v4l2_bt_timings - BT.656/BT.1120 timing data + * @width: total width of the active video in pixels + * @height: total height of the active video in lines + * @interlaced: Interlaced or progressive + * @polarities: Positive or negative polarities + * @pixelclock: Pixel clock in HZ. Ex. 74.25MHz->74250000 + * @hfrontporch:Horizontal front porch in pixels + * @hsync: Horizontal Sync length in pixels + * @hbackporch: Horizontal back porch in pixels + * @vfrontporch:Vertical front porch in lines + * @vsync: Vertical Sync length in lines + * @vbackporch: Vertical back porch in lines + * @il_vfrontporch:Vertical front porch for the even field + * (aka field 2) of interlaced field formats + * @il_vsync: Vertical Sync length for the even field + * (aka field 2) of interlaced field formats + * @il_vbackporch:Vertical back porch for the even field + * (aka field 2) of interlaced field formats + * @standards: Standards the timing belongs to + * @flags: Flags + * @reserved: Reserved fields, must be zeroed. + * + * A note regarding vertical interlaced timings: height refers to the total + * height of the active video frame (= two fields). The blanking timings refer + * to the blanking of each field. So the height of the total frame is + * calculated as follows: + * + * tot_height = height + vfrontporch + vsync + vbackporch + + * il_vfrontporch + il_vsync + il_vbackporch + * + * The active height of each field is height / 2. + */ struct v4l2_bt_timings { - __u32 width; /* width in pixels */ - __u32 height; /* height in lines */ - __u32 interlaced; /* Interlaced or progressive */ - __u32 polarities; /* Positive or negative polarity */ - __u64 pixelclock; /* Pixel clock in HZ. Ex. 74.25MHz->74250000 */ - __u32 hfrontporch; /* Horizpontal front porch in pixels */ - __u32 hsync; /* Horizontal Sync length in pixels */ - __u32 hbackporch; /* Horizontal back porch in pixels */ - __u32 vfrontporch; /* Vertical front porch in pixels */ - __u32 vsync; /* Vertical Sync length in lines */ - __u32 vbackporch; /* Vertical back porch in lines */ - __u32 il_vfrontporch; /* Vertical front porch for bottom field of - * interlaced field formats - */ - __u32 il_vsync; /* Vertical sync length for bottom field of - * interlaced field formats - */ - __u32 il_vbackporch; /* Vertical back porch for bottom field of - * interlaced field formats - */ - __u32 reserved[16]; + __u32 width; + __u32 height; + __u32 interlaced; + __u32 polarities; + __u64 pixelclock; + __u32 hfrontporch; + __u32 hsync; + __u32 hbackporch; + __u32 vfrontporch; + __u32 vsync; + __u32 vbackporch; + __u32 il_vfrontporch; + __u32 il_vsync; + __u32 il_vbackporch; + __u32 standards; + __u32 flags; + __u32 reserved[14]; } __attribute__ ((packed)); /* Interlaced or progressive format */ @@ -1019,8 +1046,42 @@ struct v4l2_bt_timings { #define V4L2_DV_VSYNC_POS_POL 0x00000001 #define V4L2_DV_HSYNC_POS_POL 0x00000002 - -/* DV timings */ +/* Timings standards */ +#define V4L2_DV_BT_STD_CEA861 (1 << 0) /* CEA-861 Digital TV Profile */ +#define V4L2_DV_BT_STD_DMT (1 << 1) /* VESA Discrete Monitor Timings */ +#define V4L2_DV_BT_STD_CVT (1 << 2) /* VESA Coordinated Video Timings */ +#define V4L2_DV_BT_STD_GTF (1 << 3) /* VESA Generalized Timings Formula */ + +/* Flags */ + +/* CVT/GTF specific: timing uses reduced blanking (CVT) or the 'Secondary + GTF' curve (GTF). In both cases the horizontal and/or vertical blanking + intervals are reduced, allowing a higher resolution over the same + bandwidth. This is a read-only flag. */ +#define V4L2_DV_FL_REDUCED_BLANKING (1 << 0) +/* CEA-861 specific: set for CEA-861 formats with a framerate of a multiple + of six. These formats can be optionally played at 1 / 1.001 speed. + This is a read-only flag. */ +#define V4L2_DV_FL_CAN_REDUCE_FPS (1 << 1) +/* CEA-861 specific: only valid for video transmitters, the flag is cleared + by receivers. + If the framerate of the format is a multiple of six, then the pixelclock + used to set up the transmitter is divided by 1.001 to make it compatible + with 60 Hz based standards such as NTSC and PAL-M that use a framerate of + 29.97 Hz. Otherwise this flag is cleared. If the transmitter can't generate + such frequencies, then the flag will also be cleared. */ +#define V4L2_DV_FL_REDUCED_FPS (1 << 2) +/* Specific to interlaced formats: if set, then field 1 is really one half-line + longer and field 2 is really one half-line shorter, so each field has + exactly the same number of half-lines. Whether half-lines can be detected + or used depends on the hardware. */ +#define V4L2_DV_FL_HALF_LINE (1 << 0) + + +/** struct v4l2_dv_timings - DV timings + * @type: the type of the timings + * @bt: BT656/1120 timings + */ struct v4l2_dv_timings { __u32 type; union { @@ -1032,6 +1093,64 @@ struct v4l2_dv_timings { /* Values for the type field */ #define V4L2_DV_BT_656_1120 0 /* BT.656/1120 timing type */ + +/** struct v4l2_enum_dv_timings - DV timings enumeration + * @index: enumeration index + * @reserved: must be zeroed + * @timings: the timings for the given index + */ +struct v4l2_enum_dv_timings { + __u32 index; + __u32 reserved[3]; + struct v4l2_dv_timings timings; +}; + +/** struct v4l2_bt_timings_cap - BT.656/BT.1120 timing capabilities + * @min_width: width in pixels + * @max_width: width in pixels + * @min_height: height in lines + * @max_height: height in lines + * @min_pixelclock: Pixel clock in HZ. Ex. 74.25MHz->74250000 + * @max_pixelclock: Pixel clock in HZ. Ex. 74.25MHz->74250000 + * @standards: Supported standards + * @capabilities: Supported capabilities + * @reserved: Must be zeroed + */ +struct v4l2_bt_timings_cap { + __u32 min_width; + __u32 max_width; + __u32 min_height; + __u32 max_height; + __u64 min_pixelclock; + __u64 max_pixelclock; + __u32 standards; + __u32 capabilities; + __u32 reserved[16]; +} __attribute__ ((packed)); + +/* Supports interlaced formats */ +#define V4L2_DV_BT_CAP_INTERLACED (1 << 0) +/* Supports progressive formats */ +#define V4L2_DV_BT_CAP_PROGRESSIVE (1 << 1) +/* Supports CVT/GTF reduced blanking */ +#define V4L2_DV_BT_CAP_REDUCED_BLANKING (1 << 2) +/* Supports custom formats */ +#define V4L2_DV_BT_CAP_CUSTOM (1 << 3) + +/** struct v4l2_dv_timings_cap - DV timings capabilities + * @type: the type of the timings (same as in struct v4l2_dv_timings) + * @bt: the BT656/1120 timings capabilities + */ +struct v4l2_dv_timings_cap { + __u32 type; + __u32 reserved[3]; + union { + struct v4l2_bt_timings_cap bt; + __u32 raw_data[32]; + }; +}; + + /* * V I D E O I N P U T S */ @@ -2412,6 +2531,12 @@ struct v4l2_create_buffers { #define VIDIOC_DECODER_CMD _IOWR('V', 96, struct v4l2_decoder_cmd) #define VIDIOC_TRY_DECODER_CMD _IOWR('V', 97, struct v4l2_decoder_cmd) +/* Experimental, these three ioctls may change over the next couple of kernel + versions. */ +#define VIDIOC_ENUM_DV_TIMINGS _IOWR('V', 96, struct v4l2_enum_dv_timings) +#define VIDIOC_QUERY_DV_TIMINGS _IOR('V', 97, struct v4l2_dv_timings) +#define VIDIOC_DV_TIMINGS_CAP _IOWR('V', 98, struct v4l2_dv_timings_cap) + /* Reminder: when adding new ioctls please add support for them to drivers/media/video/v4l2-compat-ioctl32.c as well! */ -- 1.7.10 -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html