Hello,
writing the EM28XX_R06_I2C_CLK register leads to the problem that the
i2c bus
on the Terratec Cinergy 200 USB is no longer usable when the system is
rebooted.
The device needs to be unplugged in order to bring it back to life.
Attached patch conditionally disables the write in
em28xx_pre_card_setup() like
it is already done in em28xx_card_setup().
Regards
Sascha
Do not modify EM28XX_R06_I2C_CLK for em2800
Modifying this register makes the Terratec Cinergy 200 USB unusable
after reboot.
Signed-off-by: Sascha Sommer <saschasommer@xxxxxxxxxx>
diff --git a/drivers/media/video/em28xx/em28xx-cards.c b/drivers/media/video/em28xx/em28xx-cards.c
index 897a432..0b2e6d5 100644
--- a/drivers/media/video/em28xx/em28xx-cards.c
+++ b/drivers/media/video/em28xx/em28xx-cards.c
@@ -2287,7 +2287,8 @@ void em28xx_pre_card_setup(struct em28xx *dev)
/* Set the initial XCLK and I2C clock values based on the board
definition */
em28xx_write_reg(dev, EM28XX_R0F_XCLK, dev->board.xclk & 0x7f);
- em28xx_write_reg(dev, EM28XX_R06_I2C_CLK, dev->board.i2c_speed);
+ if (!dev->board.is_em2800)
+ em28xx_write_reg(dev, EM28XX_R06_I2C_CLK, dev->board.i2c_speed);
msleep(50);
/* request some modules */
