On Sun, 2011-12-04 at 18:01 -0800, Yan Seiner wrote:
> I am experiencing a kernel oops when trying to use a Hauppage USB Live 2
> frame grabber. The oops is below.
>
> The system is a SOC 260Mhz Broadcom BCM47XX access point running OpenWRT.
>
> root@anchor:/# uname -a
> Linux anchor 3.0.3 #13 Sun Dec 4 08:04:41 PST 2011 mips GNU/Linux
>
> The OOPS could be due to the limited hardware or something else. I'd
> appreciate any suggestions for making this work. I was hoping with
> hardware compression I could make it work on this platform. I am
> currently using a Hauppage USB Live (saa7115 based) with no problems but
> with limited resolution.
>
> cx231xx v4l2 driver loaded.
> cx231xx #0: New device Hauppauge Hauppauge Device @ 480 Mbps (2040:c200) with 5 interfaces
> cx231xx #0: registering interface 1
> cx231xx #0: can't change interface 3 alt no. to 3: Max. Pkt size = 0
> cx231xx #0: can't change interface 4 alt no. to 1: Max. Pkt size = 0
> cx231xx #0: Identified as Hauppauge USB Live 2 (card=9)
> cx231xx #0: cx231xx_dif_set_standard: setStandard to ffffffff
> cx231xx #0: Changing the i2c master port to 3
> cx231xx #0: cx25840 subdev registration failure
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
The cx231xx driver requires the cx25840 module. I'll wager you didn't
install it on your router.
Regards,
Andy
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
