Em 28-09-2011 09:50, Simon Farnsworth escreveu:
> (note - the CC list is everyone over 50% certainty from get_maintainer.pl)
>
> I'm having problems getting a Hauppauge HVR-1110 card to successfully
> tune PAL-D at 85.250 MHz vision frequency; by experimentation, I've
> determined that the tda18271 is tuning to a frequency 1.25 MHz lower
> than the vision frequency I've requested, so the following workaround
> "fixes" it for me.
>
> diff --git a/drivers/media/common/tuners/tda18271-fe.c
> b/drivers/media/common/tuners/tda18271-fe.c
> index 63cc400..1a94e1a 100644
> --- a/drivers/media/common/tuners/tda18271-fe.c
> +++ b/drivers/media/common/tuners/tda18271-fe.c
> @@ -1031,6 +1031,7 @@ static int tda18271_set_analog_params(struct
> dvb_frontend *fe,
> mode = "I";
> } else if (params->std & V4L2_STD_DK) {
> map = &std_map->atv_dk;
> + freq += 1250000;
> mode = "DK";
> } else if (params->std & V4L2_STD_SECAM_L) {
> map = &std_map->atv_l;
If I am to fix this bug, instead of a hack like that, it seems to be better
to split the .atv_dk line at the struct tda18271_std_map maps on
drivers/media/common/tuners/tda18271-maps.c.
Looking at the datasheet, on page 43, available at:
http://www.nxp.com/documents/data_sheet/TDA18271HD.pdf
The offset values for IF seem ok, but maybe your device is using some variant
of this chip that requires a different maps table.
>
> I've checked with a signal analyser, and confirmed that my signal
> generator is getting the spectrum right - I am seeing vision peaking
> at 85.25 MHz, with one sideband going down to 84.5 MHz, and the other
> going up to 90.5MHz. I also see an audio carrier at 91.75 MHz.
>
> I'm going to run with this hack in place, but I'd appreciate it if
> someone who knew more about the TDA18271 looked at this, and either
> gave me a proper fix for testing, or confirmed that what I'm doing is
> right.
> --
> Simon Farnsworth
> Software Engineer
> ONELAN Limited
> http://www.onelan.com/
> --
> To unsubscribe from this list: send the line "unsubscribe linux-media" in
> the body of a message to majordomo@xxxxxxxxxxxxxxx
> More majordomo info at http://vger.kernel.org/majordomo-info.html
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
