On 06/12/2011 11:23 AM, Rune Evjen wrote:
I just tested a PCTV 290e device using the latest media_build drivers
in MythTV as a DVB-C device, and ran into some problems.
The adapter is recognized by the em28xx-dvb driver [1] and dmesg
output seems to be correct [2]. I can successfully scan for channels
using the scan utility in dvb-apps but when I try to scan for channels
in mythtv I get the following errors logged by mythtv-setup:
2011-06-12 00:57:20.971556 PIDInfo(/dev/dvb/adapter0/
frontend1): Failed to open demux device /dev/dvb/adapter0/demux1 for
filter on pid 0x0
The demux1 does not exist, I only have the following nodes under
/dev/dvb/adapter0:
demux0 dvr0 frontend0 frontend1 net0
When searching the linx-media I came across this thread:
http://www.mail-archive.com/linux-media@xxxxxxxxxxxxxxx/msg31839.html
Is there any way to circumvent with the current driver that there is
no corresponding demux1 for frontend1?
Or can the DVB-T/T2 part be disabled somehow so that there is only one
DVB-C frontend registered which corresponds to the demux0?
There is no way to say driver to create demux1 for frontend1.
After all it is not 100% clear even for me if that's correct or not, but
most likely it is correct as far as I understood.
regards,
Antti
--
http://palosaari.fi/
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
