Hi, Friday, May 6, 2011, 1:58:22 AM, you wrote: > I have 2.6.32-5-686 kernel and I have this output on dmesg: > [ 11.459771] cx23885 driver version 0.0.2 loaded > [ 11.460894] ACPI: PCI Interrupt Link [LN4A] enabled at IRQ 19 > [ 11.460914] cx23885 0000:05:00.0: PCI INT A -> Link[LN4A] -> GSI 19 (level, low) ->> IRQ 19 > [ 11.461093] CORE cx23885[0]: subsystem: d470:9022, board: TeVii > S470 [card=15,autodetected] > [ 11.587592] cx23885_dvb_register() allocating 1 frontend(s) > [ 11.587600] cx23885[0]: cx23885 based dvb card > [ 11.718813] DS3000 chip version: 0.192 attached. > [ 11.718823] DVB: registering new adapter (cx23885[0]) > [ 11.718831] DVB: registering adapter 7 frontend 0 (Montage > Technology DS3000/TS2020)... > [ 11.719476] cx23885_dev_checkrevision() Hardware revision = 0xb0 > [ 11.719490] cx23885[0]/0: found at 0000:05:00.0, rev: 2, irq: 19, > latency: 0, mmio: 0xfea00000 > [ 11.719502] cx23885 0000:05:00.0: setting latency timer to 64 > I complete the wiki page on linuxtv wiki, but I am not any expert and > english is not my best. Be careful with kernel upgrade, i had lots of > problem with 2.6.38 kernel. > Tell me how goes your progress. > Kind regards. I installed the latest s2-liplianin drivers, but I still seem to have the same issue. The card works fine for some time after reboot, then I am starting to get the following errors in the system log: May 8 11:11:38 localhost kernel: ds3000_readreg: reg=0xa1(error=-5) May 8 11:11:38 localhost kernel: ds3000_readreg: reg=0xa1(error=-5) May 8 11:11:38 localhost kernel: ds3000_readreg: reg=0xa1(error=-5) May 8 11:11:38 localhost kernel: ds3000_writereg: writereg error(err == -5, reg == 0xa1, value == 0x7b) May 8 11:11:38 localhost kernel: ds3000_readreg: reg=0xa2(error=-5) May 8 11:11:38 localhost kernel: ds3000_writereg: writereg error(err == -5, reg == 0xa2, value == 0xbb) May 8 11:11:39 localhost kernel: ds3000_readreg: reg=0xa2(error=-5) May 8 11:11:39 localhost kernel: ds3000_writereg: writereg error(err == -5, reg == 0xa2, value == 0x3b) May 8 11:11:39 localhost kernel: ds3000_writereg: writereg error(err == -5, reg == 0xa3, value == 0xe0) May 8 11:11:39 localhost kernel: ds3000_writereg: writereg error(err == -5, reg == 0xa4, value == 0x10) May 8 11:11:39 localhost kernel: ds3000_writereg: writereg error(err == -5, reg == 0xa5, value == 0x38) May 8 11:11:39 localhost kernel: ds3000_writereg: writereg error(err == -5, reg == 0xa6, value == 0xf6) May 8 11:11:39 localhost kernel: ds3000_readreg: reg=0xa1(error=-5) May 8 11:11:39 localhost kernel: ds3000_writereg: writereg error(err == -5, reg == 0xa1, value == 0x1f) May 8 11:11:39 localhost kernel: ds3000_readreg: reg=0xa1(error=-5) May 8 11:11:39 localhost kernel: ds3000_writereg: writereg error(err == -5, reg == 0xa1, value == 0x1f) May 8 11:11:39 localhost kernel: ds3000_readreg: reg=0xa1(error=-5) May 8 11:11:39 localhost kernel: ds3000_readreg: reg=0xa1(error=-5) May 8 11:11:39 localhost kernel: ds3000_readreg: reg=0xa1(error=-5) May 8 11:11:39 localhost kernel: ds3000_readreg: reg=0xa1(error=-5) May 8 11:11:39 localhost kernel: ds3000_readreg: reg=0xa1(error=-5) May 8 11:11:39 localhost kernel: ds3000_readreg: reg=0xa1(error=-5) May 8 11:11:39 localhost kernel: ds3000_readreg: reg=0xa1(error=-5) May 8 11:11:39 localhost kernel: ds3000_readreg: reg=0xa1(error=-5) May 8 11:11:39 localhost kernel: ds3000_readreg: reg=0xa1(error=-5) May 8 11:11:39 localhost kernel: ds3000_readreg: reg=0xa1(error=-5) May 8 11:11:39 localhost kernel: ds3000_readreg: reg=0xa1(error=-5) May 8 11:11:39 localhost kernel: ds3000_readreg: reg=0xa1(error=-5) May 8 11:11:39 localhost kernel: ds3000_readreg: reg=0xa1(error=-5) May 8 11:11:39 localhost kernel: ds3000_readreg: reg=0xa1(error=-5) May 8 11:11:39 localhost kernel: ds3000_readreg: reg=0xa1(error=-5) May 8 11:11:39 localhost kernel: ds3000_readreg: reg=0xa1(error=-5) May 8 11:11:39 localhost kernel: ds3000_writereg: writereg error(err == -5, reg == 0xa1, value == 0x7b) May 8 11:11:39 localhost kernel: ds3000_readreg: reg=0xa2(error=-5) May 8 11:11:39 localhost kernel: ds3000_writereg: writereg error(err == -5, reg == 0xa2, value == 0xbb) And then my machine just stops responding - even on the ssh sessions. A friend of mine installed the same S470 card a few days ago. He's using Fedora 14 (kernel 2.6.35) and he says his machine started to 'hang' sporadically, too... I guess he might have a similar issue... How could I track what is going on? -- Best regards, Andrew -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
