Hello! I need a small help. I have a remote control that was detected by kernel with the help of "ir-kbd-i2c". At least it was in Ubuntu 9.04. But now in Ubuntu 10.10 and kernel 2.6.35-26 it isn't detected. I load "ir-kbd-i2c" module but it doesn't give any output to dmesg as before. Any idea? > Date: Tue, 30 Nov 2010 13:53:12 +0100 > > > > Hello! > > I have a new remote control to add to the list of remotes supported by linux. It's detected > by kernel and almost running. DVB-T card and bundled receiver work fine. >  > But I'm a newbie and I would need some help with my remote. I'm about to find the solution but > I don't know the next step of the process. >  > Hardware: > Remote: TV713X > TV-Card: Conceptronic CTVCOMBOi (detected as Tevion/KWorld DVB-T 220RF) > Receiver: bundled in the TV-Card > Software: Ubuntu 9.04 >  > dmesg: >  > [ 8.932913] saa7130/34: v4l2 driver version 0.2.14 loaded > [ 8.933488] saa7134 0000:01:06.0: PCI INT A -> Link[LNKA] -> GSI 19 (level, low) -> IRQ 19 > [ 8.933494] saa7133[0]: found at 0000:01:06.0, rev: 209, irq: 19, latency: 64, mmio: 0xdffff800 > [ 8.933499] saa7133[0]: subsystem: 17de:7201, board: Tevion/KWorld DVB-T 220RF [card=88,autodetected] ... > sudo modprobe ir-kbd-i2c > WARNING: All config files need .conf: /etc/modprobe.d/oss-compat, it will be ignored in a future release. >  > The output in dmesg is: > [ 374.444695] input: i2c IR (KNC One) as /devices/virtual/input/input6 > [ 374.472666] ir-kbd-i2c: i2c IR (KNC One) detected at i2c-0/0-0030/ir0 [saa7133[0]] >  > And, what is more. Only when the module is loaded, if I push some buttons of the remote I have this > output in dmesg: > [ 450.228029] i2c IR (KNC One): unknown key: key=0x03 raw=0x03 down=1 > [ 450.288526] i2c IR (KNC One): unknown key: key=0x03 raw=0x03 down=0 > [ 451.248534] i2c IR (KNC One): unknown key: key=0x00 raw=0x00 down=1 > [ 451.308027] i2c IR (KNC One): unknown key: key=0x00 raw=0x00 down=0 >  ÿô.nÇ·®+%˱é¥wÿº{.nÇ·¥{±þg¯â^nr¡öë¨è&£ûz¹Þúzf£¢·h§~Ûÿÿïÿê_èæ+v¨þ)ßø