On 23/10/2010 10:20 p.m., Igor M. Liplianin wrote:
Ð ÑÐÐÐÑÐÐÐÐ ÐÑ 10 ÐÐÑÑÐ 2010 14:15:49 ÐÐÑÐÑ Hendrik Skarpeid ÐÐÐÐÑÐÐ:
Igor M. Liplianin skrev:
On 3 ÐÐÑÑÐ 2010 18:42:42 Hendrik Skarpeid wrote:
Igor M. Liplianin wrote:
Now to find GPIO's for LNB power control and ... watch TV :)
Yep. No succesful tuning at the moment. There might also be an issue
with the reset signal and writing to GPIOCTR, as the module at the
moment loads succesfully only once.
As far as I can make out, the LNB power control is probably GPIO 16 and
17, not sure which is which, and how they work.
GPIO15 is wired to tuner #reset
New patch to test
I think the LNB voltage may be a little to high on my card, 14.5V and
20V. I would be a little more happy if they were 14 and 19, 13 and 18
would be perfect.
Anyways, as Igor pointet out, I don't have any signal from the LNB,
checked with another tuner card. It's a quad LNB, and the other outputs
are fine. Maybe it's' toasted from to high supply voltage! I little word
of warning then.
Anyways, here's my tweaked driver.
Here is reworked patch for clear GPIO's handling.
It allows to support I2C on GPIO's and per board LNB control through GPIO's.
Also incuded support for Hendrik's card.
I think it is clear how to change and test GPIO's for LNB and other stuff now.
To Hendrik:
Not shure, but there is maybe GPIO for raise/down LNB voltage a little (~1v).
It is used for long coaxial lines to compensate voltage dropping.
Signed-off-by: Igor M. Liplianin<liplianin@xxxxx>
Hi Igor,
I have a brandless DVB-S tv tuner card also, with a dm1105n chip. I was
getting the "DM1105: could not attach frontend 195d:1105" message with
the latest kernel also, but I applied this patch to the dm1105 module
and now the card's being recognised (though is still listed as an
ethernet controller with lspci)
My dmesg output is:
dm1105 0000:01:05.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
DVB: registering new adapter (dm1105)
dm1105 0000:01:05.0: MAC 00:00:00:00:00:00
DVB: registering adapter 0 frontend 0 (SL SI21XX DVB-S)...
Registered IR keymap rc-dm1105-nec
input: DVB on-card IR receiver as
/devices/pci0000:00/0000:00:1e.0/0000:01:05.0/rc/rc0/input6
rc0: DVB on-card IR receiver as
/devices/pci0000:00/0000:00:1e.0/0000:01:05.0/rc/rc0
The card is one of these:
http://www.hongsun.biz/ProView.asp?ID=90
Scanning doesn't appear to give me any results. Should this be working?
Anything I can do to test the card out for you?
Cheers,
Matt.
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
