On 01/03/2025 11:48, Hans de Goede wrote:
We should put/leave the sensor in reset when requesting the GPIO, after requesting it there are 2 possible scenarios and having the GPIO driven low is no good in either scenario: 1. The sensor was in ACPI D0 before probe() runs, in this case ov08x40_power_on() + ov08x40_identify_module() will run immediately after requesting the GPIO and ov08x40_power_on() starts with driving the GPIO high. So if the GPIO was already high it will very shortly be driven low, more of a spike to low then actually properly be driven low. Which may leave the sensor in a confused state. If we request the GPIO to be high at request time then power_on() will driver it high again (no-op) and then sleep for 1-2 ms, so no spike. 2. The sensor was in ACPI D3 / off before probe(), in this case probe() leaves the sensor alone. But when the sensor is off its reset line should be driven high not low. Signed-off-by: Hans de Goede <hdegoede@xxxxxxxxxx> --- drivers/media/i2c/ov08x40.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/drivers/media/i2c/ov08x40.c b/drivers/media/i2c/ov08x40.c index c2a399e3bb41..a4790e68f523 100644 --- a/drivers/media/i2c/ov08x40.c +++ b/drivers/media/i2c/ov08x40.c @@ -2167,7 +2167,7 @@ static int ov08x40_check_hwcfg(struct ov08x40 *ov08x, struct device *dev) return dev_err_probe(dev, ret, "parsing endpoint failed\n");ov08x->reset_gpio = devm_gpiod_get_optional(dev, "reset",- GPIOD_OUT_LOW); + GPIOD_OUT_HIGH); if (IS_ERR(ov08x->reset_gpio)) { ret = dev_err_probe(dev, PTR_ERR(ov08x->reset_gpio), "getting reset GPIO\n");
Makes sense to me. Reviewed-by: Bryan O'Donoghue <bryan.odonoghue@xxxxxxxxxx>
