On 2025-02-19 16:41:24 +0200, Tomi Valkeinen wrote: > Hi, > > On 19/02/2025 16:22, Niklas Söderlund wrote: > > Hi Tomi, > > > > I'm happy to see this, nice work. > > > > Unfortunately it does not apply to the media-tree. As this series is a > > It should, if you apply the dependencies first. But one of the dependencies > from you is a bit old and that doesn't apply without some conflicts > resolved. So... Yes, doesn't apply =). :-) > > > mix of fixes and new features as well as covering multiple drivers. Do > > you think it would make sens to break out the fixes per driver which we > > could review and apply ASAP and the new features which we can review but > > need to wait until the dependencies are meet? > > Yes. I think that's the RAW8 and RAW10 fixes. However, I can't test them > without streams and GMSL2, so... Sure but the fixes for the format setup registers don't depend on streams support, right? The fixes are properly tested but depend on new features to enable hardware to produce the test environment. It's miles better then the BSP testing done when these things where first written... > > > If the new features depends on stuff that is hard to upport, maybe just > > focus on the fixes to get them out of the way? > > > > On 2025-02-19 15:48:54 +0200, Tomi Valkeinen wrote: > > > Add streams support to Renesas rcar platform driver. > > > > > > The series attempts to keep compatibility with the current upstream. > > > However, in upstream there's some kind of custom multi-stream support > > > implemented to the rcar driver, which breaks at patch "media: rcar-csi2: > > > Simplify rcsi2_calc_mbps()". > > > > I would not worry about breaking the make shift multi-stream, it was > > based on our first attempt to allow streams for GMSL many years ago and > > it was bonkers ;-) As long as it don't break a single streams, even from > > subdevs that do not themself support streams I'm happy. > > Alright. Then you're happy with this series. I hope =). I don't have > anything to test this with, and only the v4h board. You can test single stream on V4H using the staging GMSL2 driver and the TPG. I will ofc also test it so no need if it's troublesome for you to rewire the V4H you have to this configuration. -- Kind Regards, Niklas Söderlund
