The subsection on stopping the transmitter belongs to the generic part and is not specific to CSI-2. Move it out of the CSI-2 section. Signed-off-by: Sakari Ailus <sakari.ailus@xxxxxxxxxxxxxxx> --- Documentation/driver-api/media/tx-rx.rst | 19 +++++++++---------- 1 file changed, 9 insertions(+), 10 deletions(-) diff --git a/Documentation/driver-api/media/tx-rx.rst b/Documentation/driver-api/media/tx-rx.rst index 6f9eba189a9f..03768e5aa88f 100644 --- a/Documentation/driver-api/media/tx-rx.rst +++ b/Documentation/driver-api/media/tx-rx.rst @@ -62,6 +62,15 @@ to control the transmitter driver's streaming state. These callbacks may not be called directly, but by using ``v4l2_subdev_enable_streams()`` and ``v4l2_subdev_disable_streams()``. +Stopping the transmitter +^^^^^^^^^^^^^^^^^^^^^^^^ + +A transmitter stops sending the stream of images as a result of +calling the ``.disable_streams()`` callback. Some transmitters may stop the +stream at a frame boundary whereas others stop immediately, +effectively leaving the current frame unfinished. The receiver driver +should not make assumptions either way, but function properly in both +cases. CSI-2 transmitter drivers ------------------------- @@ -130,13 +139,3 @@ device, so this should be only done when it is needed. Receiver drivers that do not need explicit LP-11 or LP-111 state setup are waived from calling the two callbacks. - -Stopping the transmitter -^^^^^^^^^^^^^^^^^^^^^^^^ - -A transmitter stops sending the stream of images as a result of -calling the ``.disable_streams()`` callback. Some transmitters may stop the -stream at a frame boundary whereas others stop immediately, -effectively leaving the current frame unfinished. The receiver driver -should not make assumptions either way, but function properly in both -cases. -- 2.39.5
