Hello, This series enables support for R-Car V4M to the CSI-2 receiver. Patch 1-2 clean up some simplifications in the driver which where possible before V4M support but that now needs to be addressed. Patch 3-5 prepares for V4M support by extending some of the abstractions used in the driver to cover how they are implemented in the V4M version of the CSI-2 IP. Patch 6 improves the documentation around two registers used on Gen4 as later datasheets now document them and they will be used when enabling V4M support. And finally patch 7 adds V4M support. The V4M is similar in design to V4H with the big difference it only supports CSI-2 D-PHY. All of the media graph setup and V4L2 callbacks can be reused, only the start procedure is different. Niklas Söderlund (7): media: rcar-csi2: Correct field size for PHTW writes media: rcar-csi2: Allow writing any code and data value to PHTW media: rcar-csi2: Abstract PHTW and PHYPLL register offsets media: rcar-csi2: Add helper to lookup mbps settings media: rcar-csi2: Move PHTW write helpers media: rcar-csi2: Add documentation for PHY_EN and PHY_MODE registers media: rcar-csi2: Add support for R-Car V4M drivers/media/platform/renesas/rcar-csi2.c | 515 +++++++++++++++++---- 1 file changed, 415 insertions(+), 100 deletions(-) -- 2.45.1
