On 12/04/2024 21:20, Laurent Pinchart wrote:
Hi Tomi,
Thank you for the patch.
On Wed, Apr 10, 2024 at 03:35:54PM +0300, Tomi Valkeinen wrote:
We support camera privacy leds with the .s_stream, in call_s_stream, but
s/the .s_stream/the .s_stream() operation/
we don't have that support when the subdevice implements
.enable/disable_streams.
Add the support by enabling the led when the first stream for a
subdevice is enabled, and disabling the led then the last stream is
disabled.
I wonder if that will always be the correct constraint for all devices,
but I suppose we can worry about it later.
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@xxxxxxxxxxxxxxxx>
---
drivers/media/v4l2-core/v4l2-subdev.c | 9 +++++++++
1 file changed, 9 insertions(+)
diff --git a/drivers/media/v4l2-core/v4l2-subdev.c b/drivers/media/v4l2-core/v4l2-subdev.c
index 20b5a00cbeeb..f44aaa4e1fab 100644
--- a/drivers/media/v4l2-core/v4l2-subdev.c
+++ b/drivers/media/v4l2-core/v4l2-subdev.c
@@ -2150,6 +2150,7 @@ int v4l2_subdev_enable_streams(struct v4l2_subdev *sd, u32 pad,
{
struct device *dev = sd->entity.graph_obj.mdev->dev;
struct v4l2_subdev_state *state;
+ bool already_streaming;
u64 found_streams = 0;
unsigned int i;
int ret;
@@ -2198,6 +2199,8 @@ int v4l2_subdev_enable_streams(struct v4l2_subdev *sd, u32 pad,
dev_dbg(dev, "enable streams %u:%#llx\n", pad, streams_mask);
+ already_streaming = v4l2_subdev_is_streaming(sd);
+
/* Call the .enable_streams() operation. */
ret = v4l2_subdev_call(sd, pad, enable_streams, state, pad,
streams_mask);
@@ -2216,6 +2219,9 @@ int v4l2_subdev_enable_streams(struct v4l2_subdev *sd, u32 pad,
cfg->enabled = true;
}
+ if (!already_streaming)
+ v4l2_subdev_enable_privacy_led(sd);
+
done:
v4l2_subdev_unlock_state(state);
@@ -2340,6 +2346,9 @@ int v4l2_subdev_disable_streams(struct v4l2_subdev *sd, u32 pad,
}
done:
+ if (!v4l2_subdev_is_streaming(sd))
Wouldn't it be more efficient to check this while looping over the
stream configs in the loop just above ? Same for
v4l2_subdev_enable_streams().
It would, but it would get a lot messier to manage with "media: subdev:
Refactor v4l2_subdev_enable/disable_streams()", and we would also need
to support the non-routing case.
This is usually a loop with a couple of iterations, and only called when
enabling or enabling a subdevice, so I'm not really worried about the
performance. If it's an issue, it would probably be better to also
update the sd->enabled_pads when enabling/disabling a stream.
Tomi