There is no reason to send OV2680_END_MARGIN extra columns on top of the mode width and the same for sending extra lines over the mode height. This sending of extra lines/columns was inherited from the atomisp ov2680 driver, it is unclear why this was done and this complicates adding V4L2_CID_VBLANK support, so remove it. Signed-off-by: Hans de Goede <hdegoede@xxxxxxxxxx> --- drivers/media/i2c/ov2680.c | 9 ++------- 1 file changed, 2 insertions(+), 7 deletions(-) diff --git a/drivers/media/i2c/ov2680.c b/drivers/media/i2c/ov2680.c index 39d321e2b7f9..5b04c6c0554a 100644 --- a/drivers/media/i2c/ov2680.c +++ b/drivers/media/i2c/ov2680.c @@ -86,9 +86,6 @@ #define OV2680_PIXELS_PER_LINE 1704 #define OV2680_LINES_PER_FRAME 1294 -/* If possible send 16 extra rows / lines to the ISP as padding */ -#define OV2680_END_MARGIN 16 - /* Max exposure time is VTS - 8 */ #define OV2680_INTEGRATION_TIME_MARGIN 8 @@ -359,11 +356,9 @@ static void ov2680_calc_mode(struct ov2680_dev *sensor) sensor->mode.v_start = (sensor->mode.crop.top + (sensor->mode.crop.height - height) / 2) & ~1; sensor->mode.h_end = - min(sensor->mode.h_start + width + OV2680_END_MARGIN - 1, - OV2680_NATIVE_WIDTH - 1); + min(sensor->mode.h_start + width - 1, OV2680_NATIVE_WIDTH - 1); sensor->mode.v_end = - min(sensor->mode.v_start + height + OV2680_END_MARGIN - 1, - OV2680_NATIVE_HEIGHT - 1); + min(sensor->mode.v_start + height - 1, OV2680_NATIVE_HEIGHT - 1); sensor->mode.h_output_size = orig_width; sensor->mode.v_output_size = orig_height; sensor->mode.hts = OV2680_PIXELS_PER_LINE; -- 2.43.0
