Hi, this small series converts the driver to using CCI helpers. On top of that more clock setups are added to the driver. These are all taken from the datasheet. I suspect they all can be calculated dynamically later on. Tested on TQMa8MPxL + MBa8MPxL + ISP + Vision Components IMX415 camera. While working on the driver I notived that imx415 sets mbus code to MEDIA_BUS_FMT_SGBRG10_1X10, while imx290 uses MEDIA_BUS_FMT_SRGGB10_1X10. But the datasheets show the same color coding pattern. But both settings seem to be correct, e.g. the resulting image has correct colors. I had to remove the identity check locally. I suspect that Vision Components interjects reading some registers. Changes in v3: * Lower case register definitions * Add missing variable initialization * Fix line lengths on several locations * Simplify imx415_s_ctrl()'s cci_write usage * Suffix lane_rate (u64) values by UL Changes in v2: * Removed explicit selection of REGMAP_I2C * Dropped patch 3 for now. Mode selection shall be done by dynamic VMAX/HMAX calculations later on Best regards, Alexander Alexander Stein (2): media: i2c: imx415: Convert to new CCI register access helpers media: i2c: imx415: Add more clock configurations drivers/media/i2c/Kconfig | 1 + drivers/media/i2c/imx415.c | 670 +++++++++++++++++++++++-------------- 2 files changed, 429 insertions(+), 242 deletions(-) -- 2.34.1
