Switch from s_stream() video op to enable_streams() and disable_streams()
pad operations. They are preferred and required for streams support.
Signed-off-by: Sakari Ailus <sakari.ailus@xxxxxxxxxxxxxxx>
---
drivers/media/i2c/ccs/ccs-core.c | 183 +++++++++++++++----------------
1 file changed, 86 insertions(+), 97 deletions(-)
diff --git a/drivers/media/i2c/ccs/ccs-core.c b/drivers/media/i2c/ccs/ccs-core.c
index 7e6166e70adb..e416b7cb48c2 100644
--- a/drivers/media/i2c/ccs/ccs-core.c
+++ b/drivers/media/i2c/ccs/ccs-core.c
@@ -1705,22 +1705,64 @@ static int ccs_power_off(struct device *dev)
}
/* -----------------------------------------------------------------------------
- * Video stream management
+ * V4L2 subdev video operations
*/
-static int ccs_start_streaming(struct ccs_sensor *sensor)
+static int ccs_pm_get_init(struct ccs_sensor *sensor)
{
+ struct i2c_client *client = v4l2_get_subdevdata(&sensor->src->sd);
+ int rval;
+
+ /*
+ * It can't use pm_runtime_resume_and_get() here, as the driver
+ * relies at the returned value to detect if the device was already
+ * active or not.
+ */
+ rval = pm_runtime_get_sync(&client->dev);
+ if (rval < 0)
+ goto error;
+
+ /* Device was already active, so don't set controls */
+ if (rval == 1)
+ return 0;
+
+ /* Restore V4L2 controls to the previously suspended device */
+ rval = __v4l2_ctrl_handler_setup(&sensor->pixel_array->ctrl_handler);
+ if (rval)
+ goto error;
+
+ rval = __v4l2_ctrl_handler_setup(&sensor->src->ctrl_handler);
+ if (rval)
+ goto error;
+
+ /* Keep PM runtime usage_count incremented on success */
+ return 0;
+error:
+ pm_runtime_put(&client->dev);
+ return rval;
+}
+
+static int ccs_enable_streams(struct v4l2_subdev *subdev,
+ struct v4l2_subdev_state *state, u32 pad,
+ u64 streams_mask)
+{
+ struct ccs_sensor *sensor = to_ccs_sensor(subdev);
struct i2c_client *client = v4l2_get_subdevdata(&sensor->src->sd);
unsigned int binning_mode;
int rval;
- mutex_lock(&sensor->mutex);
+ if (pad != CCS_PAD_SRC)
+ return -EINVAL;
+
+ rval = ccs_pm_get_init(sensor);
+ if (rval)
+ return rval;
rval = ccs_write(sensor, CSI_DATA_FORMAT,
(sensor->csi_format->width << 8) |
sensor->csi_format->compressed);
if (rval)
- goto out;
+ goto err_pm_put;
/* Binning configuration */
if (sensor->binning_horizontal == 1 &&
@@ -1733,38 +1775,38 @@ static int ccs_start_streaming(struct ccs_sensor *sensor)
rval = ccs_write(sensor, BINNING_TYPE, binning_type);
if (rval < 0)
- goto out;
+ goto err_pm_put;
binning_mode = 1;
}
rval = ccs_write(sensor, BINNING_MODE, binning_mode);
if (rval < 0)
- goto out;
+ goto err_pm_put;
/* Set up PLL */
rval = ccs_pll_configure(sensor);
if (rval)
- goto out;
+ goto err_pm_put;
/* Analog crop start coordinates */
rval = ccs_write(sensor, X_ADDR_START, sensor->pa_src.left);
if (rval < 0)
- goto out;
+ goto err_pm_put;
rval = ccs_write(sensor, Y_ADDR_START, sensor->pa_src.top);
if (rval < 0)
- goto out;
+ goto err_pm_put;
/* Analog crop end coordinates */
rval = ccs_write(sensor, X_ADDR_END,
sensor->pa_src.left + sensor->pa_src.width - 1);
if (rval < 0)
- goto out;
+ goto err_pm_put;
rval = ccs_write(sensor, Y_ADDR_END,
sensor->pa_src.top + sensor->pa_src.height - 1);
if (rval < 0)
- goto out;
+ goto err_pm_put;
/*
* Output from pixel array, including blanking, is set using
@@ -1777,22 +1819,22 @@ static int ccs_start_streaming(struct ccs_sensor *sensor)
rval = ccs_write(sensor, DIGITAL_CROP_X_OFFSET,
sensor->scaler_sink.left);
if (rval < 0)
- goto out;
+ goto err_pm_put;
rval = ccs_write(sensor, DIGITAL_CROP_Y_OFFSET,
sensor->scaler_sink.top);
if (rval < 0)
- goto out;
+ goto err_pm_put;
rval = ccs_write(sensor, DIGITAL_CROP_IMAGE_WIDTH,
sensor->scaler_sink.width);
if (rval < 0)
- goto out;
+ goto err_pm_put;
rval = ccs_write(sensor, DIGITAL_CROP_IMAGE_HEIGHT,
sensor->scaler_sink.height);
if (rval < 0)
- goto out;
+ goto err_pm_put;
}
/* Scaling */
@@ -1800,20 +1842,20 @@ static int ccs_start_streaming(struct ccs_sensor *sensor)
!= CCS_SCALING_CAPABILITY_NONE) {
rval = ccs_write(sensor, SCALING_MODE, sensor->scaling_mode);
if (rval < 0)
- goto out;
+ goto err_pm_put;
rval = ccs_write(sensor, SCALE_M, sensor->scale_m);
if (rval < 0)
- goto out;
+ goto err_pm_put;
}
/* Output size from sensor */
rval = ccs_write(sensor, X_OUTPUT_SIZE, sensor->src_src.width);
if (rval < 0)
- goto out;
+ goto err_pm_put;
rval = ccs_write(sensor, Y_OUTPUT_SIZE, sensor->src_src.height);
if (rval < 0)
- goto out;
+ goto err_pm_put;
if (CCS_LIM(sensor, FLASH_MODE_CAPABILITY) &
(CCS_FLASH_MODE_CAPABILITY_SINGLE_STROBE |
@@ -1822,109 +1864,52 @@ static int ccs_start_streaming(struct ccs_sensor *sensor)
sensor->hwcfg.strobe_setup->trigger != 0) {
rval = ccs_setup_flash_strobe(sensor);
if (rval)
- goto out;
+ goto err_pm_put;
}
rval = ccs_call_quirk(sensor, pre_streamon);
if (rval) {
dev_err(&client->dev, "pre_streamon quirks failed\n");
- goto out;
+ goto err_pm_put;
}
rval = ccs_write(sensor, MODE_SELECT, CCS_MODE_SELECT_STREAMING);
-out:
- mutex_unlock(&sensor->mutex);
-
- return rval;
-}
-
-static int ccs_stop_streaming(struct ccs_sensor *sensor)
-{
- struct i2c_client *client = v4l2_get_subdevdata(&sensor->src->sd);
- int rval;
-
- mutex_lock(&sensor->mutex);
- rval = ccs_write(sensor, MODE_SELECT, CCS_MODE_SELECT_SOFTWARE_STANDBY);
- if (rval)
- goto out;
-
- rval = ccs_call_quirk(sensor, post_streamoff);
- if (rval)
- dev_err(&client->dev, "post_streamoff quirks failed\n");
-
-out:
- mutex_unlock(&sensor->mutex);
- return rval;
-}
-
-/* -----------------------------------------------------------------------------
- * V4L2 subdev video operations
- */
-
-static int ccs_pm_get_init(struct ccs_sensor *sensor)
-{
- struct i2c_client *client = v4l2_get_subdevdata(&sensor->src->sd);
- int rval;
-
- /*
- * It can't use pm_runtime_resume_and_get() here, as the driver
- * relies at the returned value to detect if the device was already
- * active or not.
- */
- rval = pm_runtime_get_sync(&client->dev);
- if (rval < 0)
- goto error;
-
- /* Device was already active, so don't set controls */
- if (rval == 1)
- return 0;
+ sensor->streaming = true;
- /* Restore V4L2 controls to the previously suspended device */
- rval = v4l2_ctrl_handler_setup(&sensor->pixel_array->ctrl_handler);
- if (rval)
- goto error;
+ return 0;
- rval = v4l2_ctrl_handler_setup(&sensor->src->ctrl_handler);
- if (rval)
- goto error;
+err_pm_put:
+ pm_runtime_mark_last_busy(&client->dev);
+ pm_runtime_put_autosuspend(&client->dev);
- /* Keep PM runtime usage_count incremented on success */
- return 0;
-error:
- pm_runtime_put(&client->dev);
return rval;
}
-static int ccs_set_stream(struct v4l2_subdev *subdev, int enable)
+static int ccs_disable_streams(struct v4l2_subdev *subdev,
+ struct v4l2_subdev_state *state, u32 pad,
+ u64 streams_mask)
{
struct ccs_sensor *sensor = to_ccs_sensor(subdev);
struct i2c_client *client = v4l2_get_subdevdata(&sensor->src->sd);
int rval;
- if (!enable) {
- ccs_stop_streaming(sensor);
- sensor->streaming = false;
- pm_runtime_mark_last_busy(&client->dev);
- pm_runtime_put_autosuspend(&client->dev);
-
- return 0;
- }
+ if (pad != CCS_PAD_SRC)
+ return -EINVAL;
- rval = ccs_pm_get_init(sensor);
+ rval = ccs_write(sensor, MODE_SELECT, CCS_MODE_SELECT_SOFTWARE_STANDBY);
if (rval)
return rval;
- sensor->streaming = true;
+ rval = ccs_call_quirk(sensor, post_streamoff);
+ if (rval)
+ dev_err(&client->dev, "post_streamoff quirks failed\n");
- rval = ccs_start_streaming(sensor);
- if (rval < 0) {
- sensor->streaming = false;
- pm_runtime_mark_last_busy(&client->dev);
- pm_runtime_put_autosuspend(&client->dev);
- }
+ sensor->streaming = false;
+ pm_runtime_mark_last_busy(&client->dev);
+ pm_runtime_put_autosuspend(&client->dev);
- return rval;
+ return 0;
}
static int ccs_pre_streamon(struct v4l2_subdev *subdev, u32 flags)
@@ -1950,7 +1935,9 @@ static int ccs_pre_streamon(struct v4l2_subdev *subdev, u32 flags)
}
}
+ mutex_lock(&sensor->mutex);
rval = ccs_pm_get_init(sensor);
+ mutex_unlock(&sensor->mutex);
if (rval)
return rval;
@@ -3046,7 +3033,7 @@ static int ccs_init_cfg(struct v4l2_subdev *sd,
}
static const struct v4l2_subdev_video_ops ccs_video_ops = {
- .s_stream = ccs_set_stream,
+ .s_stream = v4l2_subdev_s_stream_helper,
.pre_streamon = ccs_pre_streamon,
.post_streamoff = ccs_post_streamoff,
};
@@ -3058,6 +3045,8 @@ static const struct v4l2_subdev_pad_ops ccs_pad_ops = {
.set_fmt = ccs_set_format,
.get_selection = ccs_get_selection,
.set_selection = ccs_set_selection,
+ .enable_streams = ccs_enable_streams,
+ .disable_streams = ccs_disable_streams,
};
static const struct v4l2_subdev_sensor_ops ccs_sensor_ops = {
--
2.39.2
