Re: [PATCH v2 6/6] drm/vs: Add hdmi driver

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Wed, Oct 25, 2023 at 06:39:57PM +0800, Keith Zhao wrote:
> +static int starfive_hdmi_setup(struct starfive_hdmi *hdmi,
> +			       struct drm_display_mode *mode)
> +{
> +	hdmi_modb(hdmi, STARFIVE_BIAS_CONTROL, STARFIVE_BIAS_ENABLE, STARFIVE_BIAS_ENABLE);
> +	hdmi_writeb(hdmi, STARFIVE_RX_CONTROL, STARFIVE_RX_ENABLE);
> +	hdmi->hdmi_data.vic = drm_match_cea_mode(mode);

You're never using that variable.

> +	hdmi->tmds_rate = mode->clock * 1000;
> +	starfive_hdmi_phy_clk_set_rate(hdmi);
> +
> +	while (!(hdmi_readb(hdmi, STARFIVE_PRE_PLL_LOCK_STATUS) & 0x1))
> +		continue;
> +	while (!(hdmi_readb(hdmi, STARFIVE_POST_PLL_LOCK_STATUS) & 0x1))
> +		continue;
> +
> +	/*turn on LDO*/
> +	hdmi_writeb(hdmi, STARFIVE_LDO_CONTROL, STARFIVE_LDO_ENABLE);
> +	/*turn on serializer*/
> +	hdmi_writeb(hdmi, STARFIVE_SERIALIER_CONTROL, STARFIVE_SERIALIER_ENABLE);
> +
> +	starfive_hdmi_tx_phy_power_down(hdmi);
> +	starfive_hdmi_config_video_timing(hdmi, mode);
> +	starfive_hdmi_tx_phy_power_on(hdmi);
> +
> +	starfive_hdmi_tmds_driver_on(hdmi);
> +	starfive_hdmi_sync_tmds(hdmi);
> +
> +	return 0;
> +}
> +
> +static void starfive_hdmi_encoder_mode_set(struct drm_encoder *encoder,
> +					   struct drm_display_mode *mode,
> +					   struct drm_display_mode *adj_mode)
> +{
> +	struct starfive_hdmi *hdmi = encoder_to_hdmi(encoder);
> +
> +	drm_mode_copy(&hdmi->previous_mode, adj_mode);
> +}

You're never using that field, and it's not the previous mode, but the current mode.

> +static void starfive_hdmi_encoder_enable(struct drm_encoder *encoder)
> +{
> +	struct starfive_hdmi *hdmi = encoder_to_hdmi(encoder);
> +	struct drm_display_mode *mode = &encoder->crtc->state->adjusted_mode;
> +	int ret, idx;
> +	struct drm_device *drm = hdmi->connector.dev;
> +
> +	if (drm && !drm_dev_enter(drm, &idx))
> +		return;
> +
> +	ret = pm_runtime_get_sync(hdmi->dev);
> +	if (ret < 0)
> +		return;

pm_runtime_resume_and_get is what you want here

> +	mdelay(10);

???

Sprinkling delays here and there isn't great. What is the issue this is
trying to workaround?

> +	starfive_hdmi_setup(hdmi, mode);
> +
> +	if (drm)
> +		drm_dev_exit(idx);
> +}
> +
> +static void starfive_hdmi_encoder_disable(struct drm_encoder *encoder)
> +{
> +	struct starfive_hdmi *hdmi = encoder_to_hdmi(encoder);
> +
> +	int idx;
> +	struct drm_device *drm = hdmi->connector.dev;
> +
> +	if (drm && !drm_dev_enter(drm, &idx))
> +		return;
> +
> +	pm_runtime_put(hdmi->dev);

pm_runtime calls should be safe anytime. If you need to protect them
through a drm_dev_enter call, that call should be in the pm_runtime hook
itself.

> +	if (drm)
> +		drm_dev_exit(idx);
> +}
> +
> +static int
> +starfive_hdmi_encoder_atomic_check(struct drm_encoder *encoder,
> +				   struct drm_crtc_state *crtc_state,
> +				   struct drm_connector_state *conn_state)
> +{
> +	bool valid = false;
> +	struct drm_display_mode *mode = &crtc_state->adjusted_mode;
> +	struct vs_crtc_state *vs_crtc_state = to_vs_crtc_state(crtc_state);
> +
> +	vs_crtc_state->encoder_type = encoder->encoder_type;
> +	vs_crtc_state->output_fmt = MEDIA_BUS_FMT_RGB888_1X24;

Ok, so those two will always be ENCODER_TMDS and RGB888. Drop them from
your CRTC state and use the proper defines there.

> +	const struct pre_pll_config *cfg = pre_pll_cfg_table;
> +	int pclk = mode->clock * 1000;
> +
> +	for (; cfg->pixclock != 0; cfg++) {
> +		if (pclk == cfg->pixclock) {
> +			if (pclk > 297000000)
> +				continue;
> +
> +			valid = true;
> +			break;
> +		}
> +	}
> +
> +	return (valid) ? 0 : -EINVAL;
> +}
> +
> +static const struct drm_encoder_helper_funcs starfive_hdmi_encoder_helper_funcs = {
> +	.enable     = starfive_hdmi_encoder_enable,
> +	.disable    = starfive_hdmi_encoder_disable,
> +	.mode_set   = starfive_hdmi_encoder_mode_set,
> +	.atomic_check = starfive_hdmi_encoder_atomic_check,
> +};
> +
> +static enum drm_connector_status
> +starfive_hdmi_connector_detect(struct drm_connector *connector, bool force)
> +{
> +	struct starfive_hdmi *hdmi = connector_to_hdmi(connector);
> +	struct drm_device *drm = hdmi->connector.dev;
> +	int ret;
> +	int idx;
> +
> +	if (drm && !drm_dev_enter(drm, &idx))
> +		return connector_status_disconnected;
> +
> +	ret = pm_runtime_get_sync(hdmi->dev);
> +	if (ret < 0)
> +		return ret;
> +
> +	ret = (hdmi_readb(hdmi, HDMI_STATUS) & m_HOTPLUG) ?
> +		connector_status_connected : connector_status_disconnected;
> +	pm_runtime_put(hdmi->dev);
> +
> +	if (drm)
> +		drm_dev_exit(idx);
> +
> +	return ret;
> +}
> +
> +static int starfive_hdmi_connector_get_modes(struct drm_connector *connector)
> +{
> +	struct starfive_hdmi *hdmi = connector_to_hdmi(connector);
> +	struct edid *edid;
> +	int ret = 0;
> +
> +	if (!hdmi->ddc)
> +		return 0;
> +	ret = pm_runtime_get_sync(hdmi->dev);
> +	if (ret < 0)
> +		return ret;
> +
> +	edid = drm_get_edid(connector, hdmi->ddc);
> +	if (edid) {
> +		hdmi->hdmi_data.sink_is_hdmi = drm_detect_hdmi_monitor(edid);

You're not using that field anywhere, and it's available in drm_display_info already.

> +		hdmi->hdmi_data.sink_has_audio = drm_detect_monitor_audio(edid);

Ditto

> +struct hdmi_data_info {
> +	int vic;
> +	bool sink_is_hdmi;
> +	bool sink_has_audio;
> +	unsigned int enc_in_format;

You're not using it

> +	unsigned int enc_out_format;

Ditto

> +	unsigned int colorimetry;

Ditto

Which means that as things stands, you can get rid of that entire
structure.

> +};
> +
> +struct starfive_hdmi {
> +	struct device *dev;
> +	struct drm_device *drm_dev;
> +	struct drm_encoder	encoder;
> +	struct drm_connector	connector;
> +
> +	struct starfive_hdmi_i2c *i2c;
> +
> +	int irq;
> +	struct clk *sys_clk;
> +	struct clk *mclk;
> +	struct clk *bclk;
> +	struct reset_control *tx_rst;
> +	void __iomem *regs;
> +
> +	struct i2c_adapter *ddc;
> +
> +	unsigned long tmds_rate;

You're not using that either.

Maxime

Attachment: signature.asc
Description: PGP signature


[Index of Archives]     [Linux Input]     [Video for Linux]     [Gstreamer Embedded]     [Mplayer Users]     [Linux USB Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Yosemite Backpacking]

  Powered by Linux