LP-11 and LP-111 are CSI-2 bus states, not modes. Fix this. Signed-off-by: Sakari Ailus <sakari.ailus@xxxxxxxxxxxxxxx> Reviewed-by: Laurent Pinchart <laurent.pinchart@xxxxxxxxxxxxxxxx> --- Documentation/driver-api/media/tx-rx.rst | 12 ++++++------ 1 file changed, 6 insertions(+), 6 deletions(-) diff --git a/Documentation/driver-api/media/tx-rx.rst b/Documentation/driver-api/media/tx-rx.rst index b86088cc614e..9af9fa7d5197 100644 --- a/Documentation/driver-api/media/tx-rx.rst +++ b/Documentation/driver-api/media/tx-rx.rst @@ -91,8 +91,8 @@ where pixel rate on the camera sensor's pixel array which is indicated by the :ref:`V4L2_CID_PIXEL_RATE <v4l2-cid-pixel-rate>` control. -LP-11 and LP-111 modes -^^^^^^^^^^^^^^^^^^^^^^ +LP-11 and LP-111 states +^^^^^^^^^^^^^^^^^^^^^^^ As part of transitioning to high speed mode, a CSI-2 transmitter typically briefly sets the bus to LP-11 or LP-111 state, depending on the PHY. This period @@ -106,7 +106,7 @@ in software, especially when there is no interrupt telling something is happening. One way to address this is to configure the transmitter side explicitly to LP-11 -or LP-111 mode, which requires support from the transmitter hardware. This is +or LP-111 state, which requires support from the transmitter hardware. This is not universally available. Many devices return to this state once streaming is stopped while the state after power-on is LP-00 or LP-000. @@ -117,11 +117,11 @@ transitioning to streaming state, but not yet start streaming. Similarly, the to call ``.post_streamoff()`` for each successful call of ``.pre_streamon()``. In the context of CSI-2, the ``.pre_streamon()`` callback is used to transition -the transmitter to the LP-11 or LP-111 mode. This also requires powering on the +the transmitter to the LP-11 or LP-111 state. This also requires powering on the device, so this should be only done when it is needed. -Receiver drivers that do not need explicit LP-11 or LP-111 mode setup are waived -from calling the two callbacks. +Receiver drivers that do not need explicit LP-11 or LP-111 state setup are +waived from calling the two callbacks. Stopping the transmitter ^^^^^^^^^^^^^^^^^^^^^^^^ -- 2.39.2
