Re: [PATCH v13 6/8] media: dt-bindings: wave5: add Chips&Media 521c codec IP support

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 17/10/2023 15:39, Devarsh Thakkar wrote:
>> +required:
>> +  - compatible
>> +  - reg
>> +  - clocks
>> +  - interrupts
>> +
> 
> Is it possible to keep interrupts property as optional given HW can still work
> without it if SW does polling of ISR using registers?
> 
> The reason to ask is in TI AM62A SoC (which also uses this codec) there is an
> SoC errata of missing interrupt line to A53 and we are using SW based polling
> locally to run the driver.
> 
> We were planning to upstream that SW based polling support patch in CnM driver
> once this base initial driver patch series gets merged, but just wanted to
> check if upfront it is possible to have interrupts property as optional so
> that we don't have to change the binding doc again to make it optional later on.
> 
> Also note that the polling patch won't be specific to AM62A, other SoC's too
> which use this wave5 hardware if they want can enable polling by choice (by
> removing interrupt property)
> 
> Could you please share your opinion on this ?

You know, if you do not have interrupt line connected, how could it be
required, right? If the hardware does not require interrupt to be
connected then bindings should not require it.

Best regards,
Krzysztof




[Index of Archives]     [Linux Input]     [Video for Linux]     [Gstreamer Embedded]     [Mplayer Users]     [Linux USB Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Yosemite Backpacking]

  Powered by Linux