On Wed, Sep 06, 2023 at 03:50:57PM +0300, Laurent Pinchart wrote: > On Wed, Sep 06, 2023 at 12:43:44PM +0000, Sakari Ailus wrote: > > > > -2) Streams. Streams are declared and their routing is configured by > > > > -setting the routing table for the sub-device using > > > > -:ref:`VIDIOC_SUBDEV_S_ROUTING <VIDIOC_SUBDEV_G_ROUTING>` ioctl. Note that > > > > -setting the routing table will reset formats and selections in the > > > > -sub-device to default values. > > > > +2) Streams. Streams are declared and their routing is configured by setting the > > > > + routing table for the sub-device using :ref:`VIDIOC_SUBDEV_S_ROUTING > > > > + <VIDIOC_SUBDEV_G_ROUTING>` ioctl. Note that setting the routing table will > > > > + reset formats and selections in the sub-device to default values. > > > > > > > > -3) Configure formats and selections. Formats and selections of each stream > > > > -are configured separately as documented for plain sub-devices in > > > > -:ref:`format-propagation`. The stream ID is set to the same stream ID > > > > -associated with either sink or source pads of routes configured using the > > > > -:ref:`VIDIOC_SUBDEV_S_ROUTING <VIDIOC_SUBDEV_G_ROUTING>` ioctl. > > > > +3) Configure formats and selections. Formats and selections of each stream are > > > > + configured separately as documented for plain sub-devices in > > > > + :ref:`format-propagation`. The stream ID is set to the same stream ID > > > > + associated with either sink or source pads of routes configured using the > > > > + :ref:`VIDIOC_SUBDEV_S_ROUTING <VIDIOC_SUBDEV_G_ROUTING>` ioctl. > > > > > > > > Multiplexed streams setup example > > > > ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ > > > > @@ -619,8 +618,8 @@ modeled as V4L2 devices, exposed to userspace via /dev/videoX nodes. > > > > To configure this pipeline, the userspace must take the following steps: > > > > > > > > 1) Set up media links between entities: connect the sensors to the bridge, > > > > -bridge to the receiver, and the receiver to the DMA engines. This step does > > > > -not differ from normal non-multiplexed media controller setup. > > > > + bridge to the receiver, and the receiver to the DMA engines. This step does > > > > + not differ from normal non-multiplexed media controller setup. > > > > > > > > 2) Configure routing > > > > > > > > > > 3) below contains two paragraphs that are not indented. > > > > From the documentation output this does not matter. Or was your comment > > about aligning the formatting in the source? (I prefer it as-is but no > > strong opinion about it either. Just slightly easier to edit that way. :-)) > > I like consistency, both in the source and the output :-) This doesn't seem to be possible in all cases --- Sphinx thinks the paragraph is part of the preceding table if it's indented. -- Sakari Ailus
